Many coastlines around the world are protected by dikes with shallow foreshores (e.g. salt marshes and mudflats) that attenuate storm waves and are expected to reduce the likelihood and volume of waves overtopping the dikes behind them. However, most of the studies to date that assessed their effectiveness have excluded the influence of infragravity (IG) waves, which often dominate in shallow water. Here, we propose a modular and adaptable framework to estimate the probability of coastal dike failure by overtopping waves (Pf). The influence of IG waves on overtopping is included using an empirical approach, which is first validated against observations made during two recent storms (2015 and 2017). The framework is then applied to compare the Pf values of the dikes along the Dutch Wadden Sea coast with and without the influence of IG waves. Findings show that including IG waves results in 1.1 to 1.6 times higher Pf values, suggesting that safety is overestimated when they are neglected. This increase is attributed to the influence of the IG waves on the design wave period and, to a lesser extent, the wave height at the dike toe. The spatial variation in this effect, observed for the case considered, highlights its dependence on local conditions – with IG waves showing greater influence at locations with larger offshore waves, such as those behind tidal inlets, and shallower water depths. Finally, the change in Pf due to the IG waves varied significantly depending on the empirical wave overtopping model selected, emphasizing the importance of tools developed specifically for shallow foreshore environments.@en

This paper presents the first field measurements with an innovative laser scanner system, during an actual severe winter storm with very oblique wave attack. The goal of this paper is to validate this innovative system for measuring wave run-up and wave overtopping parameters during storms with very oblique wave attack. The paper describes the analysis of the run-up and overtopping data obtained during storm Ciara (10 - 12 February 2020) and validates the results with data from overtopping tanks and video recordings. Storm Ciara was a highly unique and complex storm, with offshore-directed wind and alongshore-directed waves at the dike. This posed large challenges for measuring the front velocities. The wave run-up heights and the overtopping discharges could be measured accurately with the laser scanners. Reasonable results were achieved for the run-up depths. This has led to several new insights into the probability distribution of oblique wave run-up and the run-up depths of up-rushing oblique waves. Larger deviations were found for the 2D front velocities and wave angle of incidence, which could not be determined as well for storm Ciara. This arose from the highly complex conditions during Ciara with very oblique wave attack. The mobile system is now ready to be used at several different locations in the measurement campaign in this area over the coming years.@en

Wave overtopping is typically measured in the field using overtopping tanks. In this paper, an alternative system is developed that uses two laser scanners. The system also measures wave run-up, as well as run-up depths and velocities, both during perpendicular and oblique waves on a dike in the field. The paper considers the first calibration tests with the system in the field, with perpendicular and oblique waves generated by the wave run-up simulator on a grass dike slope. Furthermore, simulations are performed with the numerical wave model SWASH, to gain more insight in the potential performance of the system during actual oblique wave attack during a storm. The run-up is determined from the measured elevation and reflection intensity, which agrees well with the visually observed run-up. Run-up depths and front velocities can be determined accurately as well. The (virtual) wave overtopping discharge can be calculated from the data, which agrees well with the most commonly used overtopping equations for perpendicularly incident waves. Finally, from the simulated run-up data of obliquely incident waves, it is concluded that an estimate can be obtained of the incident wave period and wave angle of incidence at the toe of the structure.@en

Oosterlo et al. (2019) developed a system using two terrestrial laser scanners, which can measure run-up heights, depths and velocities of waves on a dike in field situations. The system has now been placed next to two overtopping tanks on a dike in the Eems-Dollard estuary in the Netherlands to measure during actual severe winter storms. The goal of the present paper is to further validate this innovative system with data obtained during storm Ciara (10 - 12 February 2020), a severe winter storm with very oblique wave attack. Furthermore, the data gathered during storm Ciara will be compared to the current knowledge on wave overtopping, to possibly gain new insights in the influence of very oblique wave attack on wave overtopping.@en

Practitioners often employ diverse, though not always thoroughly validated, numerical models to directly or indirectly estimate wave overtopping (q) at sloping structures. These models, broadly classified as either phase-resolving or phase-averaged, each have strengths and limitations owing to the physical schematization of processes within them. Models which resolve the vertical flow structure or the full wave spectrum (i.e. sea-swell (SS) and infragravity (IG) waves) are considered more accurate, but more computationally demanding than those with approximations. Here, we assess the speed-accuracy trade-off of six well-known models for estimating q, under shallow foreshore conditions. The results demonstrate that: i) q is underestimated by an order of magnitude when IG waves are neglected; ii) using more computationally-demanding models does not guarantee improved accuracy; and iii) with empirical corrections to incorporate IG waves, phase-averaged models like SWAN can perform on par, if not better than, phase-resolving models but with far less computational effort.

@en

Despite the widely recognized role of infragravity (IG) waves in many often-hazardous nearshore processes, spectral wave models, which exclude IG-wave dynamics, are often used in the design and assessment of coastal dikes. Consequently, the safety of these structures in environments where IG waves dominate remains uncertain. Here, we combine physical and numerical modeling to: (1) assess the influence of various offshore, foreshore, and dike slope conditions on the dominance of IG waves over those at sea and swell (SS) frequencies; and (2) develop a predictive model for the relative magnitude of IG waves, defined as the ratio of the IG-to-SS-wave height at the dike toe. Findings show that higher, directionally narrow-banded incident waves; shallower water depths; milder foreshore slopes; reduced vegetated cover; and milder dike slopes promote IG-wave dominance. In addition, the empirical model derived, which captures the combined effect of the varied environmental parameters, allows practitioners to quickly estimate the significance of IG waves at the coast, and may also be combined with spectral wave models to extend their applicability to areas where IG waves contribute significantly.

@en

Oosterlo et al. (2019) developed a system using two terrestrial laser scanners, which can measure run-up heights, depths and velocities of waves on a dike in field situations. The system has now been placed next to two overtopping tanks on a dike in the Eems-Dollard estuary in the Netherlands to measure during actual severe winter storms. The goal of the present paper is to further validate this innovative system with data obtained during storm Ciara (10 - 12 February 2020), a severe winter storm with very oblique wave attack. Furthermore, the data gathered during storm Ciara will be compared to the current knowledge on wave overtopping, to possibly gain new insights in the influence of very oblique wave attack on wave overtopping.@en

Wave overtopping is commonly measured using overtopping tanks. In this paper, an alternative system is developed by using two laser scanners. It measures wave run-up, as well as layer thicknesses and front velocities, both during normally and obliquely incident waves on a dike in the field. The paper considers the first field validation tests with the system, with normal and oblique waves generated by the wave run-up simulator on a grass dike slope. Furthermore, a range of environmental conditions are simulated, to determine the robustness of the system. From the measured distance and reflection, the run-up is determined, which corresponds well to the observed run-up. From the data, the layer thickness and front velocity are determined as well. Layer thicknesses and front velocities are determined reliably with the laser scanners. Also, the (virtual) wave overtopping discharge can be calculated, which corresponds well with the most commonly used overtopping equations.@en

Shallow foreshores in front of coastal dikes can reduce the probability of dike failure due to wave overtopping. A probabilistic model framework is presented, which is capable of including complex hydrodynamics like infragravity waves, and morphological changes of a sandy foreshore during severe storms in the calculations of the probability of dike failure due to wave overtopping. The method is applied to a test case based on the Westkapelle sea defence in The Netherlands, a hybrid defence consisting of a dike with a sandy foreshore. The model framework consists of the process-based hydrological and morphological model XBeach, probabilistic overtopping equations (EurOtop) and the level III fully probabilistic method ADIS. By using the fully probabilistic level III method ADIS, the number of simulations necessary is greatly reduced, which allows for the use of more advanced and detailed hydro- and morphodynamic models. The framework is able to compute the probability of failure with up to 15 stochastic variables and is able to describe feasible physical processes. Furthermore, the framework is completely modular, which means that any model or equation can be plugged into the framework, whenever updated models with improved representation of the physics or increases in computational power become available. The model framework as described in this paper, includes more physical processes and stochastic variables in the determination of the probability of dike failure due to wave overtopping, compared to the currently used methods in The Netherlands. For the here considered case, the complex hydrodynamics like infragravity waves and wave set-up need to be included in the calculations, because they appeared to have a large influence on the probability of failure. Morphological changes of the foreshore during a severe storm appeared to have less influence on the probability of failure for this case. It is recommended to apply the framework to other cases as well, to determine if the effects of complex hydrodynamics as infragravity waves and morphological changes on the probability of sea dike failure due to wave overtopping as found in this paper hold for other cases as well. Furthermore, it is recommended to investigate broader use of the method, e.g., for safety assessment, reliability analysis and design.@en

This paper considers the Eems-Dollard estuary in the north of the Netherlands, which is part of the shallow shelf sea the Wadden Sea. This estuary is a highly complex area with tidal flats and deep channels and is characterised by an offshore directed wind, posing a challenge to wave prediction models. As little measurements are available, a measurement campaign is set up to provide field data for verifying and improving these wave models. The paper presents the locations that are most suited for wave measurements in the estuary, insight in the performance of the phase-averaged numerical wave model SWAN, and insight in the processes that play a role in the area around the corner of the Eemshaven. Furthermore, it presents insight into the reliability and applicability of SWAN in this highly complex area. An analysis of propagation effects is performed, as well as a comparison between the SWAN version as used for the Dutch dike safety assessment and the newest version, used for development, which includes the state of the art parameterisations of the physics. Furthermore, modelling is done for a schematised version of the area around the corner of the Eemshaven, considering several different model settings. Large differences occur in the results between the two SWAN versions. These differences are studied in more detail, and the causes of these differences are identified.@en

The strength of the grass sod is an important factor for the stability of a dike in the Netherlands during wave overtopping conditions. Many tests have been performed the last few years with the Wave Overtopping Simulator, leading to the Cumulative Overload Method and a critical velocity. This velocity is a strength parameter of grass on a dike under loads induced by overtopping wave volumes. A new method has been developed to determine this critical velocity, by measuring the force while lifting the grass sod perpendicular to the slope out of the sod. This force is rewritten into the critical grass normal stress which is one of the input parameters for determining the critical velocity of a grass sod. When the critical velocity resulting from this method is compared with the determined critical velocities with the Wave Overtopping Simulator, there is good correspondence between the results for the tested locations. Therefore the sod pulling test could provide results that are reliable enough to determine the critical velocity of a dike section.

@en

The goal of this work is to present a synthesis of the improvements and updates developed to deliver the final version of the ANN tool adopted by the second edition of the wave overtopping manual, EurOtop, released on the internet in 2016. This tool consists of three identical but independent ANNs able to predict the main parameters representative of the wave-structure interaction processes, i.e. The mean wave overtopping discharge, the wave transmission and the wave reflection coefficients. The contribution focuses on the modifications of the ANN architecture carried out since the last ICCE conference to achieve an optimized representation of the wave overtopping, especially in case of low and extreme values of the overtopping discharge. The consistency of the ANN predictions is assessed through an artificial dataset including geometrical and climate input parameters that are varied with continuity, while the robustness of the tool is checked by applying the ANN to selected geometries excluded from the training database.@en

This thesis focuses on the erosion of the grass sod during overtopping wave volumes. Several tests have been performed in the last few years with the wave overtopping simulator. During this thesis, some of these locations have been tested for the strength of the grass sod with a newly developed method. This new method, called the sod pulling method, tests the actual strength of the grass by lifting the grass sod out of the top layer. The measured forces needed to lift the grass sod can be rewritten into critical grass normal stresses. Furthermore, the displacement is measured as a function of the measured force.@en

In VAN GENT [2004] graphs were presented in which the datasets of VAN DER MEER [1988] and VAN GENT ET AL. [2003] were compared, but in this comparison a number of parameters were not correctly transformed into a comparable format. In this M.Sc. thesis after an extensive analysis to the datasets all parameters of the datasets of Van der Meer were transformed into the same format as the parameters used by Van Gent. In the same way the dataset of THOMPSON & SHUTTLER [1975], which formed the basis of the work of Van der Meer, was treated. The inclusion of correction factors for the effects of stone roundness from LATHAM ET AL. [1988] gave remarkable effects on a certain part of the dataset of Van der Meer which showed more damage than average. After this still differences could be seen between the datasets of Van der Meer and Van Gent. Using the statistical T-test these differences are approved.@en