Nearshore hydro- and morphodynamic data were collected during a field experiment under calm conditions, moderate conditions, and storm conditions with dune erosion in the collision regime. The experiment was conducted on the Sand Engine near Kijkduin, the Netherlands, from October 18, 2021, to January 7, 2022. Two artificial unvegetated dunes were constructed just above the high water line to measure storm erosion and dune impacts from higher water levels and waves. During the experiment, three storms occurred that resulted in significant erosion of both dunes. The collected hydrodynamic data include pressure sensor and velocimeter data along two cross-shore transects. The collected morphodynamic data include bathymetry and topography surveys, optical backscatter sensor data in the inner surf zone, and a continuous cross-shore line-scanning lidar data set of the dune face. This comprehensive data set can be used to (1) study relevant nearshore hydrodynamic and morphodynamic processes that occur during calm conditions, moderate conditions, and storm conditions with dune erosion in the collision regime, and (2) validate existing dune erosion models.@en

A field experiment to study dune erosion was conducted on the Sand Engine near Kijkduin, the Netherlands, from November 7th 2021 to January 7th 2022. Two artificial unvegetated dunes were constructed near the high water line, and experienced significant erosion through avalanching during three storms. This paper aims to identify what drives dune erosion through avalanching by using the collected data and equilibrium theory. Results suggest that the cumulative volume eroded through avalanching during a single high water is positively correlated with the profile mismatch between the pre-storm profile and a ‘storm equilibrium profile’, described by a 2/3rd power law, an empirical coefficient A, and the total water level. This mismatch is quantified by calculating the area integral of the profile that is acquired when the upper 35 m of the pre-storm profile is subtracted from the upper 35 m of the equilibrium profile. Avalanching commences when this mismatch becomes larger than approximately 0, after which 1 m3/m of sediment erodes from the dune face for every 3 m3/m mismatch. In addition, during one event avalanching occurred even though the elevation of the total water level did not exceed the initial elevation of the dune toe. This implies that a total water level that exceeds the initial elevation of the dune toe is not a requisite for avalanching and a collision regime to occur, which contradicts conventional definitions of dune erosion regimes. These results have implications on risk assessment of storm conditions on dune erosion.@en

Storm conditions can lead to excessive dune erosion with potential floods as a consequence. Barrier islands and low-lying countries protected by dunes are especially vulnerable to dune erosion. To properly assess the risks these areas face, a clear understanding of the physical processes during dune erosion is required. One of such processes is the effect of wave obliquity on sediment transport in the surf zone. Classic dune erosion models assume that dune erosion volumes decrease under oblique wave attack, because the time-averaged cross-shore undertow decreases in magnitude and with that offshore directed sediment transport decreases (Steetzel, 1993). More recent process-based erosion models predict an increase in erosion quantities, because the generated longshore currents increase surf zone sediment concentrations, and with that offshore directed sediment transport increases (Den Heijer, 2013). The main objective of this study is to analyse the effect of wave obliquity on dune erosion through a field experiment, by quantifying the effect of the decreasing undertow but increasing alongshore current on sediment concentrations in the surf zone. @en

Storm conditions can lead to excessive dune erosion with potential floods as a consequence. Barrier islands and low-lying countries protected by dunes are especially vulnerable to dune erosion. To properly assess the risks these areas face, a clear understanding of the physical processes during dune erosion is required. An international field experiment was conducted to study dune erosion during storm surges from November 6 2021 until January 6 2022. on the Sand Engine. During the Realdune/Reflex experiment, two prototype un-vegetated dunes of 5.5 m high and 150 m long were built just above the high waterline. Due to a different shoreline orientation and nearshore bathymetry, these dunes eroded differently during moderate storm conditions. 3 storms were captured during the campaign. This abstract presents preliminary results of morphodynamic change during these 3 storms, by means of profile changes and erosion volumes.@en

Meteotsunami waves can be triggered by atmospheric disturbances accompanying tropical cyclone rainbands (TCRs) before, during, and long after a tropical cyclone (TC) makes landfall. Due to a paucity of high-resolution field data along open coasts during TCs, relatively little is known about the atmospheric forcing that generate and resonantly amplify these ocean waves, nor their coastal impact. This study links high-resolution field measurements of sea level and air pressure from Hurricane Harvey (2017) with a numerical model to assess the potential for meteotsunami generation by sudden changes in air pressure accompanying TCRs. Previous studies, through the use of idealized models, have suggested that wind is the dominant forcing mechanism for TCR-induced meteotsunami with negligible contributions from air pressure. Our model simulations show that large air pressure perturbations (∼1–3 mbar) can generate meteotsunamis that are similar in period (∼20 min) and amplitude (∼0.2 m) to surf zone observations. The measured air pressure disturbances were often short in wavelength, which necessitates a numerical model with high temporal and spatial resolution to simulate meteotsunami triggered by this mechanism. Sensitivity analysis indicates that air pressure forcing can produce meteotsunami with amplitudes O(0.5 m) and large spatial extents, but model results are sensitive to atmospheric factors, including model uncertainties (length, forward translation speed, and trajectory of the air pressure disturbance), as well as oceanographic factors (storm surge). The present study provides observational and numerical evidence that suggest that air pressure perturbations likely play a larger role in meteotsunami generation by TCRs than previously identified.

@en

Infragravity (IG) waves are expected to contribute significantly to coastal flooding and sediment transport during hurricane overwash, yet the dynamics of these low-frequency waves during hurricane impact remain poorly documented and understood. This paper utilizes hydrodynamic measurements collected during Hurricane Harvey (2017) across a low-lying barrier-island cut (Texas, U.S.A.) during sea-to-bay directed flow (i.e., overwash). IG waves were observed to propagate across the island for a period of five hours, superimposed on and depth modulated by very-low frequency storm-driven variability in water level (5.6 min to 2.8 h periods). These sea-level anomalies are hypothesized to be meteotsunami initiated by tropical cyclone rainbands. Estimates of IG energy flux show that IG energy was largely reduced across the island (79-86%) and the magnitude of energy loss was greatest for the lowest-frequency IG waves (<0.01 Hz). Using multitaper bispectral analysis, it is shown that, during overwash, nonlinear triad interactions on the sea-side of the barrier island result in energy transfer from the low-frequency IG peak to bound harmonics at high IG frequencies (>0.01 Hz). Assuming this pattern of nonlinear energy exchange persists across the wide and downward sloping barrier-island cut, it likely contributes to the observed frequency-dependence of cross-barrier IG energy losses during this relatively low surge event (<1 m)

@en