F.A. Veer
Please Note
78 records found
1
- Young’s modulus
- tensile, compressive and shear stress
- fracture toughness (as a standard measure of structural material safety).
Although this can be reduced to mere numbers, as illustrated in Figure 5.1 for the major structural materials, an understanding of these numbers will help to make correct design choices. In addition, the twenty-first century structural designer has a responsibility to make choices that minimise eco-impact and as such this aspect also requires some understanding of eco properties. ...
- Young’s modulus
- tensile, compressive and shear stress
- fracture toughness (as a standard measure of structural material safety).
Although this can be reduced to mere numbers, as illustrated in Figure 5.1 for the major structural materials, an understanding of these numbers will help to make correct design choices. In addition, the twenty-first century structural designer has a responsibility to make choices that minimise eco-impact and as such this aspect also requires some understanding of eco properties.
This paper aims to provide a systematical review of the available printing strategies, sustainable cementitious materials and characterization methods for extrusion-based 3D concrete printing (3DCP). The printing strategies, consisting of printing setup, process, and material requirements, were summarized initially. In the material aspect, the high ordinary Portland cement (OPC) content in most printable mixtures is a major issue that impedes the sustainability of 3DCP. This can be resolved by partially substituting OPC with supplementary cementitious materials (SCMs). In this review, the effect of different SCMs on fresh-state behaviors and 3D printing of cementitious materials was comprehensively discussed. Finally, a series of test methods for quantitively characterizing fresh properties, 3D printability and interlayer behaviors were summarized and reviewed.
Fill-In-Glass Restoration
Exploring Issues Of Compatibility For The Case Of Schaesberg Castle
The Production and Performance of Heat Bonded Glass Connections
An Experimental Study
The applicability of glass in structures is continuously ascending, as the transparency and high compressive strength of the material render it the optimum choice for realizing diaphanous structural components that allow for light transmittance and space continuity. The fabrication boundaries of the material are constantly stretching: visible metal connections are minimized and glass surfaces are maximized, resulting to pure all-glass structures. Still, due to the prevalence of the float glass industry, all-glass structures are currently confined to the limited forms and shapes that can be generated by planar, 2D glass elements. Moreover, despite the fact that glass is fully recyclable, most of the glass currently employed in buildings is neither reused nor recycled due to its perplexed disassembly and its contamination from coatings and adhesives. Cast glass can be the answer to the above restraints, as it can escape the design limitations generated from the 2-dimensional nature of float glass. By pouring molten glass into moulds, solid 3-dimensional glass components can be attained of considerably larger cross-sections and of virtually any shape. These monolithic glass objects can form repetitive units for large all glass-structures that do not buckle due to slender proportions and thus can take full advantage of the stated compressive strength of glass. Such components can be accordingly shaped to interlock towards easily assembled structures that do not require the use of adhesives for further bonding. In addition, cast glass units–due to their increased cross section– can tolerate a higher degree of impurities and thus can be produced by using waste glass as a raw source.