This paper introduces the use of structural topology optimization (TO) as a new design approach that enables the creation of monolithic load-bearing cast glass components of substantial dimensions with significantly reduced annealing times, rendering such components viable in terms of manufacturing. Using topology optimization, the glass mass can be optimized to match design loads whilst maintaining high stiffness and a homogeneous mass for even cooling. Initially, the two main TO approaches are discussed in terms of suitability for cast glass. A strain-based optimization is eventually preferred over Von Mises optimization in the specific study. To explore the potential of TO for optimizing structural cast glass components, three distinct studies are analyzed in ANSYS workbench: (i) a structural glass node, (ii) a cast glass floor and (iii) a pedestrian bridge. These lead to the establishment of a set of design/input criteria, taking into account glass as a material, casting as a manufacturing method, addressing also the safety of the structure. The design studies also reveal the inherent challenges of using TO for load-bearing glass components, which, in turn, lead to the establishment of design guidelines for developing a TO tool specifically for glass. Towards the real-life applicability of such complex-shaped, customized components, possible manufacturing methods are also discussed.@en

This paper explores two alternative mould fabrication technologies that allow for the casting of (solid) glass components with a great degree of freedom in shape and size and/or of a customized design, in a cost-efficient way. In specific, the paper discusses the research, design and experimental work conducted at TU Delft on 3D-printed sand moulds and adjustable, high-precision steel moulds. 3D-printed sand moulds can provide a high-accuracy, cost-effective solution for solid glass components of complex geometry and/or of customized design. Although this mould technique is already used for metal castings, it remains still unexplored in the field of glass casting. Accordingly, this paper presents the first experimental findings at TU Delft of this mould technology: mould samples using different binders and treated with various coatings for surface finishing are tested in the high temperatures anticipated in glass (kiln-)casting. Following, 3D-printed moulds are prepared for a given glass geometry and physical glass prototypes are made by kiln-casting. Adjustable metal moulds are another mould technique that offers a degree of freedom in the modulus of a structure. Essentially, components of different sizes and, to an extent, shapes can be generated by the same mould. Accordingly, the design principles and engineering of such a mould and the potential applications and limitations of this technology are discussed. As a proof of concept, an adjustable mould is made using 3D-printed PLA and laser-cut MDF. The mould is used for the generation of wax models of variable forms, which are used to kiln-cast glass prototypes by the lost-wax technique. Based on the findings on both presented mould technologies, guidelines are given on their suitability according to the production volume, the level of accuracy required and the complexity and variation of forms involved. @en