Active galactic nuclei (AGN) have been observed as far as redshift. They are crucial in investigating the early Universe as well as the growth of supermassive black holes at their centres. Radio-loud AGN with their jets seen at a small viewing angle are called blazars and show relativistic boosting of their emission. Thus, their apparently brighter jets are easier to detect in the high-redshift Universe. DES J014132.4-542749.9 is a radio-luminous but X-ray weak blazar candidate at. We conducted high-resolution radio interferometric observations of this source with the Australian Long Baseline Array at and GHz. A single, compact radio-emitting feature was detected at both frequencies with a flat radio spectrum. We derived the milliarcsecond-level accurate position of the object. The frequency dependence of its brightness temperature is similar to that of blazar sources observed at lower redshifts. Based on our observations, we can confirm its blazar nature. We compared its radio properties with those of two other similarly X-ray-weak and radio-bright AGN, and found that they show very different relativistic boosting characteristics.

The difficulties for selective metal recovery from electronic waste are induced by the high complexity of such waste stream and complicated purification procedures. In this research, an electrochemical stimulated method is demonstrated to selective recover copper from an industrially provided electronic waste. More specific, one-step selective copper recovery was achieved by combining electrochemical dissolution and deposition in ammonia-based electrolyte. In the process, copper instead of other impure metals from the electronic waste is selectively dissolved and electrochemically enhanced at the anode. On the other side of the cell, pure copper was electrodeposited at the cathode. The current efficiency was found to be significantly influenced by the applied current density if galvanostatic process was facilitated. Both temperature and copper concentration in the electrolyte were found to have positive effects on the current efficiency. In a well-controlled process, copper of 99.56 wt% purity can be obtained which can be further improved by preventing potential oxidation on the electrodeposited layer. This research provide a possibility for selective copper recovery in one-step by substantially decreasing the purification cost and simplifying copper recovery procedures from electronic waste.