Strain engineering is one of the most effective approaches to manipulate the physical state of materials, control their electronic properties, and enable crucial functionalities. Because of their rich phase diagrams arising from competing ground states, quantum materials are an ideal playground for on-demand material control and can be used to develop emergent technologies, such as adaptive electronics or neuromorphic computing. It was recently suggested that complex oxides could bring unprecedented functionalities to the field of nanomechanics, but the possibility of precisely controlling the stress state of materials is so far lacking. Here, we demonstrate the wide and reversible manipulation of the stress state of single-crystal WO₃ by strain engineering controlled by catalytic hydrogenation. Progressive incorporation of hydrogen in freestanding ultrathin structures determines large variations of their mechanical resonance frequencies, inducing static deformation. Our results demonstrate hydrogen doping as a new paradigm to reversibly manipulate the mechanical properties of nanodevices based on materials control.

@en

In the past years, the use of highly sensitive silicon microelectromechanical cantilevers has been proposed as a tool to characterize the spin-crossover phenomenon by employing fast optical readout of the motion. In this work, Fe ^II -based spin-crossover nanoparticles of the well-known [Fe(Htrz) ₂ (trz)](BF ₄ ) complex wrapped with thin silica shells of different sizes will be studied by means of silicon microresonators. The silica shell will enhance its chemical stability, whereas the low thickness will allow a proper mechanical coupling between the cantilever and the spin-crossover core. To maximize the sensing of the spin-crossover phenomena, different cantilever geometries and flexural modes were employed. In addition, the experimental observations were also compared with COMSOL numerical simulations, which are in close agreement with them. The probe of spin-crossover phenomena with micro- and nanoelectromechanical actuators offers the possibility of preparing smart sensing memory devices near/above room temperature.

@en

We explore the superconducting phase diagram of the two-dimensional electron system at the LaAlO3/SrTiO3 interface by monitoring the frequencies of the cavity modes of a coplanar waveguide resonator fabricated in the interface itself. We determine the phase diagram of the superconducting transition as a function of the temperature and electrostatic gating, finding that both the superfluid density and the transition temperature follow a dome shape but that the two are not monotonically related. The ground state of this two-dimensional electron system is interpreted as a Josephson junction array, where a transition from long- to short-range order occurs as a function of the electronic doping. The synergy between correlated oxides and superconducting circuits is revealed to be a promising route to investigate these exotic compounds, complementary to standard magnetotransport measurements.

@en

One of the hallmark experiments of quantum transport is the observation of the quantized resistance in a point contact in GaAs/AlGaAs heterostructures. Being formed with split gate technology, these structures represent in an ideal manner equilibrium reservoirs which are connected only through a few electron mode channel. It has been a long standing goal to achieve similar experimental conditions also in superconductors. Here we demonstrate the formation of a superconducting quantum point contact (SQPC) with split gate technology in a two-dimensional superconductor, utilizing the unique gate tunability of the superfluid at the LaAlO₃/SrTiO₃ interface. When the constriction is tuned through the action of metallic split gates we identify three regimes of transport: First, SQPC for which the supercurrent is carried only by a few quantum transport channels. Second, superconducting island strongly coupled to the equilibrium reservoirs. Third, charge island with a discrete spectrum weakly coupled to the reservoirs.

@en

Relating the band structure of correlated semimetals to their transport properties is a complex and often open issue. The partial occupation of numerous electron and hole bands can result in properties that are seemingly in contrast with one another, complicating the extraction of the transport coefficients of different bands. The 5d oxide SrIrO3 hosts parabolic bands of heavy holes and light electrons in gapped Dirac cones due to the interplay between electron-electron interactions and spin-orbit coupling. We present a multifold approach relying on different experimental techniques and theoretical calculations to disentangle its complex electronic properties. By combining magnetotransport and thermoelectric measurements in a field-effect geometry with first-principles calculations, we quantitatively determine the transport coefficients of different conduction channels. Despite their different dispersion relationships, electrons and holes are found to have strikingly similar transport coefficients, yielding a holelike response under field-effect and thermoelectric measurements and a linear electronlike Hall effect up to 33 T.

@en

Strongly correlated materials show unique solid-state phase transitions with rich nanoscale phenomenology that can be controlled by external stimuli. Particularly interesting is the case of light–matter interaction in the proximity of the metal–insulator transition of heteroepitaxial nickelates. In this work, we use near-infrared laser light in the high-intensity excitation regime to manipulate the nanoscale phase separation in NdNiO3. By tuning the laser intensity, we can reproducibly set the coverage of insulating nanodomains, which we image by photoemission electron microscopy, thus semipermanently configuring the material state. With the aid of transport measurements and finite element simulations, we identify two different timescales of thermal dynamics in the light–matter interaction: a steady-state and a fast transient local heating. These results open interesting perspectives for locally manipulating and reconfiguring electronic order at the nanoscale by optical means.@en

Hydrogen-related technologies are rapidly developing, driven by the necessity of efficient and high-density energy storage. This poses new challenges to the detection of dangerous gases, in particular the realization of cheap, sensitive, and fast hydrogen sensors. Several materials are being studied for this application, but most present critical bottlenecks, such as high operational temperature, low sensitivity, slow response time, and/or complex fabrication procedures. Here, we demonstrate that WO₃ in the form of single-crystal, ultrathin films with a Pt catalyst allows high-performance sensing of H₂ gas at room temperature. Thanks to the high electrical resistance in the pristine state, this material is able to detect hydrogen concentrations down to 1 ppm near room temperature. Moreover, the high surface-to-volume ratio of WO₃ ultrathin films determines fast sensor response and recovery, with characteristic times as low as 1 s when the concentration exceeds 100 ppm. By modeling the hydrogen (de)intercalation dynamics with a kinetic model, we extract the energy barriers of the relevant processes and relate the doping mechanism to the formation of oxygen vacancies. Our results reveal the potential of single-crystal WO₃ ultrath@en

Relaxation oscillators consist of periodic variations of a physical quantity triggered by a static excitation. They are a typical consequence of nonlinear dynamics and can be observed in a variety of systems. VO₂ is a correlated oxide with a solid-state phase transition above room temperature, where both electrical resistance and lattice parameters undergo a drastic change in a narrow temperature range. This strong nonlinear response allows to realize spontaneous electrical oscillations in the megahertz range under a DC voltage bias. These electrical oscillations are employed to set into mechanical resonance a microstructure without the need of any active electronics, with small power consumption and with the possibility to selectively excite specific flexural modes by tuning the value of the DC electrical bias in a range of few hundreds of millivolts. This actuation method is robust and flexible and can be implemented in a variety of autonomous DC-powered devices.

@en

Superconducting coplanar waveguide (CPW) resonators are powerful and versatile tools used in areas ranging from radiation detection to circuit quantum electrodynamics. Their potential for low intrinsic losses makes them attractive as sensitive probes of electronic properties of bulk materials and thin films. Here we use superconducting MoRe CPW resonators to investigate the high-frequency (up to 0.3 GHz) and low-temperature (down to 3.5 K) permittivity of SrTiO3, a nonlinear dielectric on the verge of a ferroelectric transition (quantum paraelectricity). We perform a quantitative analysis of its dielectric properties as a function of external dc bias (up to ±15V), rf power, and mode number and discuss our results within the framework of the most recent theoretical models. We also discuss the origin of a fatigue effect that reduces the tunability of the dielectric constant of SrTiO3, which we relate to the presence of oxygen vacancies.

@en

Novel physical phenomena arising at the interface of complex oxide heterostructures offer exciting opportunities for the development of future electronic devices. Using the prototypical LaAlO₃/SrTiO₃ interface as a model system, we employ a single-step lithographic process to realize gate-tunable Josephson junctions through a combination of lateral confinement and local side gating. The action of the side gates is found to be comparable to that of a local back gate, constituting a robust and efficient way to control the properties of the interface at the nanoscale. We demonstrate that the side gates enable reliable tuning of both the normal-state resistance and the critical (Josephson) current of the constrictions. The conductance and Josephson current show mesoscopic fluctuations as a function of the applied side gate voltage, and the analysis of their amplitude enables the extraction of the phase coherence and thermal lengths. Finally, we realize a superconducting quantum interference device in which the critical currents of each of the constriction-type Josephson junctions can be controlled independently via the side gates.

@en

Interfaces between complex oxides constitute a unique playground for two-dimensional electron systems (2DESs), where superconductivity and magnetism can arise from combinations of bulk insulators. The 2DES at the LaAlO₃/SrTiO₃ interface is one of the most studied in this regard, and its origin is determined by the polar field in LaAlO₃ as well as by the presence of point defects, like oxygen vacancies and intermixed cations. These defects usually reside in the conduction channel and are responsible for a decrease of the electronic mobility. In this work, we use an amorphous WO₃ overlayer to obtain a high-mobility 2DES in WO₃/LaAlO₃/SrTiO₃ heterostructures. The studied system shows a sharp insulator-to-metal transition as a function of both LaAlO₃ and WO₃ layer thickness. Low-temperature magnetotransport reveals a strong magnetoresistance reaching 900% at 10 T and 1.5 K, the presence of multiple conduction channels with carrier mobility up to 80 000 cm² V^-1 s^-1, and quantum oscillations of conductance.

@en

We investigate the thickness-dependent electronic properties of ultrathin SrIrO3 and discover a transition from a semimetallic to a correlated insulating state below 4 unit cells. Low-temperature magnetoconductance measurements show that spin fluctuations in the semimetallic state are significantly enhanced while approaching the transition point. The electronic properties are further studied by scanning tunneling spectroscopy, showing that 4 unit cell SrIrO3 is on the verge of a gap opening. Our density functional theory calculations reproduce the critical thickness of the transition and show that the opening of a gap in ultrathin SrIrO3 requires antiferromagnetic order.

@en

Nucleation processes of mixed-phase states are an intrinsic characteristic of first-order phase transitions, typically related to local symmetry breaking. Direct observation of emerging mixed-phase regions in materials showing a first-order metal-insulator transition (MIT) offers unique opportunities to uncover their driving mechanism. Using photoemission electron microscopy, we image the nanoscale formation and growth of insulating domains across the temperature-driven MIT in NdNiO₃ epitaxial thin films. Heteroepitaxy is found to strongly determine the nanoscale nature of the phase transition, inducing preferential formation of striped domains along the terraces of atomically flat stepped surfaces. We show that the distribution of transition temperatures is a local property, set by surface morphology and stable across multiple temperature cycles. Our data provide new insights into the MIT of heteroepitaxial nickelates and point to a rich, nanoscale phenomenology in this strongly correlated material.

@en

Obtaining high-quality thin films of 5d transition metal oxides is essential to explore the exotic semimetallic and topological phases predicted to arise from the combination of strong electron correlations and spin-orbit coupling. Here, we show that the transport properties of SrIrO₃ thin films, grown by pulsed laser deposition, can be optimized by considering the effect of laser-induced modification of the SrIrO₃ target surface. We further demonstrate that bare SrIrO₃ thin films are subject to degradation in air and are highly sensitive to lithographic processing. A crystalline SrTiO₃ cap layer deposited in-situ is effective in preserving the film quality, allowing us to measure metallic transport behavior in films with thicknesses down to 4 unit cells. In addition, the SrTiO₃ encapsulation enables the fabrication of devices such as Hall bars without altering the film properties, allowing precise (magneto)transport measurements on micro- and nanoscale devices.

@en

Combination of electric fields and Joule self-heating is used to change the oxygen stoichiometry and promote oxygen vacancy drift in a freestanding (La,Sr)MnO3 thin film microbridge placed in controlled atmosphere. By controlling the local oxygen vacancies concentration, we can reversibly switch our (La,Sr)MnO3-based microbridges from metallic to insulating behavior on timescales lower than 1 s and with small applied voltages (@en