Sub-mm astronomy in space calls for an array of photon noise limited detectors, both for imaging and broadband spectroscopy. Microwave Kinetic Inductance Detectors (MKIDs), superconducting resonance circuits, are a suitable candidate for this purpose due to its multiplexing poten
...
Sub-mm astronomy in space calls for an array of photon noise limited detectors, both for imaging and broadband spectroscopy. Microwave Kinetic Inductance Detectors (MKIDs), superconducting resonance circuits, are a suitable candidate for this purpose due to its multiplexing potential, but in literature excess noise in phase readout is encountered and attributed to so-called two-level systems (TLSs). Reduction in TLS induced noise and loss will provide greater flexibility in design and a route towards background limited detector performance.
In this thesis, TLSs from surface and bulk sources are modelled, so that their behaviour can be predicted through numerical computations of the field distributions inside the resonators. These calculations not only provide a guide for sensible chip designs, but allow for interpretation of experimental data and determination of dominant TLS sources.
It is found that for Al CPW resonators on Si or SiN, the noise is surface dominated but with a non-negligible bulk contribution, while for microstrips on a SiN membrane, the noise is bulk dominated. As the loss in microstrips for narrow microstrips is dominated by the substrate-air interface, the dominant TLS loss and noise sources do not necessarily coincide and should be treated independently. This makes it impossible to determine the dominant CPW surface noise contribution. Additionally, microstrips and CPWs on the same dielectric perform similarly, while Si is better than SiN, both in terms of loss and noise, due to a combination of SiN interface and bulk effects. Finally, material dependent loss and noise parameters have been determined and the importance of thorough Si surface cleaning has been established, yielding the best Al CPW noise ever encountered.
For sub-mm astronomy in space, the logical path to improvement would be the use of thorough cleaned Si as a dielectric, overetching and the use of LEKIDS and hybrid resonators, where microstrips are still viable for use. Importantly, having located the important TLS locations for various cases, tackling these problems areas further could provide the step towards background limited performance in space.