High temperature biosyngas cleaning is more efficient when the end user operates at elevated temperature, as in biomass gasifier solid oxide fuel cell systems. However, there is not much experience with this technology and low temperature gas cleaning is usually adopted. This paper advances current knowledge by presenting the results from the investigation of side reactions catalysed by commercially available sorbents involving biosyngas main components, and the results obtained with the pilot plant developed within the Horizon2020 project “Flexifuel-SOFC”. K₂CO₃, used for HCl removal, appeared catalytically active towards the water gas shift reaction. Under conditions representative of a real system, the residence time was not sufficient for the gas composition to reach thermodynamic equilibrium. ZnO–CuO, used for H₂S removal, showed a catalytic activity significantly higher. Both sorbents seemed not active towards the methanation reaction. The pilot plant tests confirmed the occurrence of the WGS reaction in the HCl removal reactor. The sorbents decreased H₂S and HCl below the target value of 1 ppmv for H₂S and 5 ppmv for HCl. The catalytic activity of sorbents and the heat released by these reactions should be carefully considered in the design phase of high temperature gas cleaning units.

@en

Fundamental studies focusing on the electrode kinetics are essential in understanding the fuel cell operation and optimizing the electrode designs. In this study, we determined the triple-phase boundary (TPB)-based kinetics of hydrogen electrochemical oxidation using nickel patterned electrode experimental data and the Butler-Volmer formalism of the oxidation process. The same kinetics are then incorporated in a cermet electrode electrochemical model to estimate the effective TPB density of the nickel/yittrium-stabilized zirconia cermet anode. The kinetics are found to be of the same order of magnitude as previously determined by the microstructure reconstruction of cermet anode. Simulation results further revealed that the effective TPB density is several orders of magnitude lower than the typically reported physical densities of the cermet anode that possibly suggests that only a minor fraction of the physical TPB is actually required or available to produce the cell current at given cell voltage. The effect of various operating conditions on the anode activation overpotential is also investigated and discussed in this study.

@en

A summary of research activities and on-going multiple projects at Delft University of Technology aimed at the development of Solid Oxide Fuel Cells (SOFCs) integrated waste to energy systems are presented in this paper. A wide range of studies ranging from pattern cell impedance analysis to integrated system development is also presented. Cleaning the gas to match constraints of SOFCs requires complex approaches. A brief discussion on the achievable system efficiencies with SOFC integrated waste to energy systems is presented and novel concepts such as gasifier-Reversible SOFC integrated power production cum energy storage systems are discussed. Additionally, an overview of a wide range of national, European and international projects that helped or currently helping us to carry out the above mentioned research activities are presented.@en