Distinguishing between photothermal and non-thermal contributions is essential in plasmon catalysis. Use of a tailored optical temperature sensor based on fiber Bragg gratings enabled us to obtain an accurate temperature map of an illuminated plasmonic catalyst bed with high spatiotemporal resolution. Its importance for quantification of the photothermal and non-thermal contributions to plasmon catalysis is demonstrated using a Ru/Al₂O₃ catalyst. Upon illumination with LEDs, we measured temperature differences exceeding 50 °C in the top 0.5 mm of the catalyst bed. Furthermore, we discovered differences between the surface temperature and the temperature obtained via conventional thermocouple measurements underneath the catalyst bed exceeding 200 °C at 2.6 W cm⁻² light intensity. This demonstrates that accurate multi-point temperature measurements are a prerequisite for a correct interpretation of catalysis results of light-powered chemical reactions obtained with plasmonic catalysts.

Plasmonic CO₂ methanation using γ-Al₂O₃-supported Ru nanorods was carried out under continuous-flow conditions without conventional heating, using mildly concentrated sunlight as the sole and sustainable energy source (AM 1.5, irradiance 5.5–14.4 kW·m⁻² = 5.5–14.4 suns). Under 12.5 suns, a CO₂ conversion exceeding 97% was achieved with complete selectivity towards CH₄ and a stable production rate (261.9 mmol·g^{−1 Ru·h−1}) for at least 12 h. The CH₄ production rate showed an exponential increase with increasing light intensity, suggesting that the process was mainly promoted by photothermal heating. This was confirmed by the apparent activation energy of 64.3 kJ·mol⁻¹, which is very similar to the activation energy obtained for reference experiments in dark (67.3 kJ·mol⁻¹). The flow rate influence was studied under 14.4 suns, achieving a CH₄ production plateau of 264 µmol min⁻¹ (792 mmol·g^{−1 Ru·h−1}) with a constant catalyst bed temperature of approximately 204^◦C.

Sunlight-powered reduction of CO₂ to fuels and chemicals is a promising strategy to close the carbon loop and facilitate the energy transition. In this research, we demonstrate that Au nanoparticles supported on TiO₂ are an efficient plasmonic catalyst for the sunlight-powered reverse water-gas shift (rWGS) reaction. A maximum CO production rate of 429 mmol ⋅ g_Au⁻¹ ⋅ h⁻¹ with a selectivity of 98 % and an apparent quantum efficiency of 4.7 % were achieved using mildly concentrated sunlight (1.44 W ⋅ cm⁻² equals 14.4 sun). The CO production rate showed an exponential increase with increasing light intensity, suggesting that the process is mainly promoted by a photothermal effect. Thermal reference experiments with the same catalysts promoted CH₄ formation, dropping the CO selectivity to 70 %. Thus, mildly concentrated sunlight can efficiently and selectively enhance the promotion of the rWGS reaction without using external heating.

Hyperbolic Meta-Materials (HMMs) are anisotropic materials with permittivity tensor that has both positive and negative eigenvalues. Here we report that by using a type II HMM as cladding material, a waveguide which only supports higher order modes can be achieved, while the lower order modes become leaky and are absorbed in the HMM cladding. This counter-intuitive property can lead to novel application in optical communication and photonic integrated circuit. The loss in our HMM-Insulator-HMM (HIH) waveguide is smaller than that of similar guided mode in a Metal-Insulator-Metal (MIM) waveguide.

Au and Ag nanoshells are of interest for a wide range of applications. The plasmon resonance of such nanoshells is the property of interest and can be tuned in a broad spectral regime, ranging from the ultraviolet to the mid-infrared. To date, a large number of manuscripts have been published on the optics of such nanoshells. Few of these, however, address the effect of particle size distribution and metal shell imperfections on the plasmon resonance. Both are inherent to the chemical synthesis of metal nanoshells and therefore to a large extent unavoidable. It is of vital importance to understand their effect on the plasmon resonance, since this determines the scope and limitations of the technology and may have a direct impact on the application of such particles. Here, we elucidate the effect of particle size distribution and imperfections in the metal shell on the plasmon resonance of Au and Ag nanoshells. The size of the polystyrene core and the thickness of the Au and Ag shells are systematically varied to study their influence on the plasmon resonance, and the results are compared to values obtained through optical simulations using extended Mie theory and finite element method. Discrepancies between theory and practice are studied in detail and discussed extensively. Quantitative information on the minimum thickness of the metal shell, which is required to realize a satisfactory plasmon resonance of a metal nanoshell, is provided for Au and Ag.

The demand for indoor navigation is increasingly urgent in many applications such as safe management of underground spaces or location services in complex indoor environment, e.g. shopping centres, airports, museums, underground parking lot and hospitals. Indoor navigation is still a challenging research field, as currently applied indoor navigation algorithms commonly ignore important environmental and human factors and therefore do not provide precise navigation. Flexible and detailed networks representing the connectivity of spaces and considering indoor objects such as furniture are very important to a precise navigation. In this paper we concentrate on indoor navigation considering obstacles represented as polygons. We introduce a specific space subdivision based on a simplified floor plan to build the indoor navigation network. The experiments demonstrate that we are able to navigate around the obstacles using the proposed network. Considering to well-known path-finding approaches based on Medial Axis Transform (MAT) or Visibility Graph (VG), the approach in this paper provides a quick subdivision of space and routes, which are compatible with the results of VG.