Tomographic imaging based on ambient seismic noise measurements has shown to be a powerful tool, especially in areas like Iceland, where the microseism illumination is excellent. In this paper, we produce a 3D S-wave tomographic image over the western Reykjanes Peninsula high-enthalpy geothermal fields and evaluate the reliability of the tomographic results for different resolutions through simulated and real data. We use 30 broadband stations operating for approximately one-and-a-half year and apply ambient noise seismic interferometry for each station-pair. This results in empirical Green's functions in which especially the ballistic surface waves (BSW) are well resolved. The retrieved BSW exhibit a high signal-to-noise ratio between 0.1 and 0.5 Hz, and the beamforming analysis indicates an apparent surface-wave velocity of 3 km/s over a broad azimuthal range. For the tomographic inversion, we invert the estimated phase velocities between all station pairs to frequency-dependent phase velocity maps in four different resolutions (1, 2, 3, and 4 km) using a Tikhonov regularisation. With the estimated regularisation parameter per frequency per resolution, we invert simulated data for checkerboard sensitivity tests per frequency for different combinations of velocity anomaly sizes and resolutions.

Finally, after the inversion to depth, we detect S-wave velocity anomalies with variations between −15% and 15% with reference to an estimated average velocity using 1 km and 3 km of lateral resolutions and 1 km of vertical resolution. This study shows the potential of ambient noise tomography as complementary seismological tool for reservoir characterization.@en

Tomographic studies based on passive seismic measurements have proven to be a powerful tool to image the subsurface. This especially holds in areas like Iceland, where the microseism coverage arriving from the ocean is excellent. In this study, we apply Ambient Noise Seismic Interferometry (ANSI) to generate a tomographic image of Rayleigh-waves velocity anomalies to further invert for S-wave anomalies at two Icelandic locations. We derive a tomographic image over Reykjanes Peninsula geothermal system using 30 Broad-Band (BB) stations deployed under the IMAGE (Integrated Methods for Advanced Geothermal Exploration) project framework and operated for approximately one year and a half. In the other case study, we derive a tomographic image of Torfajökull volcano using 23 BB seismometers that recorded ambient noise for 100 days. The later data were acquired in 2005 by Cambridge University. We retrieve the surface-wave part of the Green’s functions by cross-correlation between station pairs and consecutive stacking of the cross-correlations to obtain coherent ballistic surface waves (BSW). We pick the arrival times of the BSW, which are the input for the tomographic analysis. Both datasets show remarkably high signal-to-noise ratio of surface-wave arrivals between 0.1 and 0.5 Hz, even with only 100 days of recorded ambient noise. A beamforming analysis indicates a broad azimuthal coverage with persistent ambient noise arrivals within three azimuthal quadrants - between 90 and 360 degrees. The highly coherent surface-wave retrieval and the wide azimuthal coverage of the microseisms explain the success of ANSI techniques in Iceland. For the tomographic inversion, we use a Tikhonov and a statistical regularisation to invert the ballistic surface-wave time-arrival to 3D frequency-dependent velocity variations. After further inversion to S-wave velocity variations, we detect low- and high-velocity anomalies with changes between -15% and 15% from an estimated average velocity, we interpret these anomalies as possible old dyke intrusions and heat sources.@en