LW

L.F.A. Wymenga

info

Please Note

7 records found

COLD atmospheric plasma (CAP) is an electrically charged (or partially ionized) gas at or around room temperature. When produced in ambient air, it exists as a cloud of positive and negative ions, energy-rich electrons, UV light, visible light and temporary reactive species (reactive oxygen and nitrogen species or RONS). CAP can be produced by using high-voltage electrodes. When the electric field in air becomes high enough, ambient air temporarily transforms into CAP.

CAP can be used for applications such as disinfection, wastewater treatment and surface activation. Its RONS are able to break down molecules in air and water. For example, studies show that CAP can break down pharmaceutical drug residues in water. CAP could break down methane in air. It could inactivate (or kill) microorganisms such as bacteria, viruses and fungi. Furthermore, CAP was used to (chemically) treat polymer surfaces, making them electrically charged or more attracted to water.

These examples show that CAP might become very useful in industrial processes. However, CAP is currently sparsely applied for processes such as disinfection, air treatment and water cleaning. This limited implementation is partly due to technical constraints related to electrical efficiency, heat production and material degradation. One of the most reliable devices to create CAP in ambient air is the dielectric barrier discharge (DBD). But even most DBDs suffer from these constraints.

In this dissertation, these constraints are partially or wholly addressed. The technical issues that limit DBD scalability and implementation are clearly investigated in a literature review. Subsequently, approaches to DBD optimization are investigated. Finally, based on these findings, novel DBD designs are built and installed with a proper high-voltage powering circuit. These DBDs are then tested for several practical applications.

In Chapter 2, the literature review can be found. In Chapter 3, a novel DBD electrode geometry, which we call interfractal electrodes, is described and tested. In Chapter 4, a novel type of DBD is built and evaluated for its capability to disinfect crop seeds from pathogenic bacteria and fungi. In Chapter 5, a DBD is built and optimized to inactivate flu virus aerosols in-air. In Chapter 6, we describe a novel DBD-based method to treat polymer surfaces. This method, which we call pulsed DBD + ion extraction, allows for efficient charge storage in polymer sheets (such charged polymers are called electrets).

Our findings are summarized in Chapter 7, and recommendations are given to accelerate the industrial implementation of CAP technology. ...
Seed production is a vital part of the global food supply chain. Seed surfaces are often contaminated with pathogenic fungal spores and bacteria, which cause plant diseases during germination. These pathogens prevent healthy crop growth and reduce yields by up to 40% in major crops. The future use of pesticides will be restricted by increasingly stringent regulations, while the demand for healthy crops continues to rise. Therefore, there is a growing need for eco-friendly technologies to inactivate seed-borne pathogenic microorganisms, without compromising seed quality. Cold atmospheric plasma (CAP) offers a promising alternative. Generated in ambient air, CAP is an ionized gas containing electrons, photons, ions, and reactive oxygen and nitrogen species (RONS). It does not leave toxic residues. Although CAP has demonstrated effective microbial inactivation at laboratory scale, its industrial implementation remains limited due to challenges in scalability, reliability and heat production. In this study, these limitations are addressed by developing and optimizing a wire-plate dielectric barrier discharge (DBD) for CAP seed disinfection, powered by high voltage pulses. The seed disinfection efficacy of the DBD was evaluated for cabbage and carrot seeds contaminated with bacteria (Xanthomonas campestris pv. campestris (Xcc) and Xanthomonas hortorum pv. carotae (Xhc)) and fungal spores (Alternaria brassicicola). Key parameters (such as treatment time, operating voltage and seed positioning) were investigated. The individual contribution of several plasma components (such as accelerated ions, RONS, pulsed electric fields) to seed disinfection was examined. Our results demonstrate that a large-area pulsed wire-plate DBD can achieve effective disinfection, while no reduction in seedling growth was observed. This highlights its potential as a scalable and sustainable alternative to conventional seed disinfection methods. ...
Journal article (2026) - Luutzen F.A. Wymenga, Suzanne M.A. Mijnhardt, Mohamad Ghaffarian Niasar, Willem D. van Driel, Guo Qi Zhang, Pieter L.A. Fraaij, Ron A.M. Fouchier, Sander Herfst
Respiratory virus infections pose a major public health burden and pandemic risk, especially when they are transmissible via the air. Consequently, there is an urgent need for effective control measures to mitigate airborne transmission. Cold atmospheric plasma (CAP) offers a promising solution for in-air virus inactivation by exposing viruses to a mixture of electrons, ions, photons, and reactive oxygen and nitrogen species (RONS). Here, a grating dielectric barrier discharge (DBD) panel consisting of 88 glass-covered electrodes was developed. Plasma formation using a high-voltage neon transformer was confirmed across all electrodes, with a power deposition of approximately 5 W. In an open acrylic tube, representative of an air duct, ozone levels increased to a maximum of 90 ppm and returned to zero within 30 s after the DBD panel was turned off. The obstructing area of the electrodes was 13%, resulting in a lower pressure drop than the current standard HEPA filters. The DBD panel was further tested in an aerosol chamber where the viability of artificially aerosolized influenza A virus (IAV) after a single passage through the DBD panel was assessed. Plaque assays showed that virus inactivation increased with exposure time, reaching 96.9% inactivation after 15 s of exposure and up to 99.9% inactivation when aerosolization followed prior RONS accumulation, whereas RNA levels and air temperature remained largely unaffected. These results demonstrate that in-duct DBD panels can effectively inactivate IAV in aerosols without leaving persistent toxic residues. This proof-of-concept study might give future directions for implementation of CAP technology in high-risk settings such as hospitals, livestock facilities, and transportation hubs to reduce the spread of infectious virus in the environment. ...
Low-temperature atmospheric plasma (LTP) is widely used in industrial processes, such as disinfection, surface modification and wastewater treatment. The dielectric barrier discharge (DBD) is regarded as one of the most robust and reliable methods for generating LTP in ambient air. Compared to conventional AC excitation, pulsed powering offers several advantages (i.e., lower energy use and heat production). The present trend is to use short and fast pulses (in the nano- and picosecond range). In this review, the key design parameters of a DBD (barrier thickness, relative permittivity and gap distance) are discussed. Material-specific phenomena like surface charging and degradation are analyzed. The complex interactions between the pulse source and DBD are examined. By mapping the interdependencies, this review aims to support the rational design and optimization of pulsed DBD systems, and to facilitate their broader industrial use. ...
Cold atmospheric plasma (CAP) is widely used in domains such as disinfection, surface treatment and food preservation. When generated in air, CAP is rich in reactive oxygen and nitrogen species (RONS), such as ozone (O3). A dielectric barrier discharge (DBD) is a reliable method to create CAP. We developed a double-sided (twin) surface DBD with novel ‘interfractal’ electrode geometries. This fractal configuration creates stronger electric fields than the customary interdigital line geometry. So, CAP is produced more effectively, resulting in higher RONS concentrations. The performance of interfractal electrodes was compared to that of interdigital electrodes (IDE) in atmospheric air. Nanopulsed powering was used, since it is the most efficient for powering DBDs. Electrical and chemical characteristics (such as ozone level) were assessed. The results show that interfractal electrodes enhance the electric field, conduction current and ozone yield. ...
Journal article (2024) - Zichuan Li, Luutzen Wymenga, Jiajie Fan, Guoqi Zhang
This study demonstrates a breakdown analysis of the dynamics of a liquid crystal elastomer (LCE) including quality check, geometric measurement, thermal characterization, and comparison of heat- and light-induced contractions. A blue light-responsive acrylate side chain LCE with 1% azobenzene dye was characterized. From a classical viewpoint, photo-thermal contraction is considered a dominating effect, while direct photo-mechanical deformation can be neglected due to a low dye percentage. However, the findings of this research suggest that a low percentage of azobenzene dye does not necessarily lead to heat-dominating dynamics of LCE. This phenomenon has not yet been quantitatively studied before. The approach reported in this Letter can potentially be used to extract the data to improve the dynamics models of light-driven LCEs. ...
Micro-devices that use electric fields to trap, analyze and inactivate micro-organisms vary in concept, design and application. The application of electric fields to manipulate and inactivate bacteria and single-celled organisms has been described extensively in the literature. By contrast, the effect of such fields on viruses is not well understood. This review explores the possibility of using existing methods for manipulating and inactivating larger viruses and bacteria, for smaller viruses, such as SARS-CoV-2. It also provides an overview of the theoretical background. The findings may be used to implement new ideas and frame experimental parameters that optimize the manipulation, sampling and inactivation of SARS-CoV-2 electrically. ...