Orthogonal fracture networks form an arrangement of open well-connected fractures which have perpendicular abutment angles and sometimes show topological relations by which fracture sets abut against each other, thus forming a nested network. Previous modelling studies have shown that orthogonal fractures may be caused by a local stress perturbation rather than a rotation in remote stresses. In this study, we expand on the implications of these local stress perturbations using a static finite element approach. The derived stress field is examined to assess the development of implemented microfractures. The results show that the continuous infill of fractures leads to a gradual decrease in the local tensile stresses and strain energies, and, therefore, results in the development of a saturated network, at which further fracture placement is inhibit. The geometry of this fully developed network is dependent on the remote effective stresses and partly on the material properties. Saturated networks range from: (1) a set of closely spaced parallel fractures; (2) a ladder-like geometry; and (3) an interconnected nested arrangement. Finally, we show that our modelling results at which we apply effective tension, are equivalent to having a uniformly distributed internal pore fluid pressure, when assuming static steady state conditions and no dynamic fluid behaviour.

@en

The potential of shale reservoirs for gas extraction is largely determined by the permeability of the rock. Typical pore diameters in shales range from the μm down to the nm scale. The permeability of shale reservoirs is a function of the interconnectivity between the pore space and the natural fracture network present. We have measured the permeability of the Whitby Mudstone, the exposed counterpart of the Posidonia Shales buried in the Dutch subsurface and a possible target for unconventional gas, using different methods and established a correlation with the microstructures and pore networks present down to the nanometer scale. Whitby Mudstone is a clay rich rock with a low porosity. The permeability of the Whitby Mudstone is in the range of 10⁻¹⁸m²–10⁻²¹m². 2D microstructures of the Whitby Mudstone show no connected pore networks, but isolated pore bodies mainly situated in the clay matrix, whereas 3D data shows that connected pore networks are present in less compacted parts of the rock. A closely spaced interconnected fracture network is often required to speed up transport of fluids from the matrix into a producing well. For fluids within the matrix the nearest natural fracture is on average at a distance of approximately 10cm in the Whitby Mudstone. The combination of the permeability data and the porosity data with natural fracture spacing of the fractures present in outcrops along the Yorkshire coast (UK) resulted in new insights into possible fluid pathways from reservoir to well.

@en

Orthogonal fracture networks (ladder-like networks) are arrangements that are commonly observed in outcrop studies. They form a particularly dense and well connected network which can play an important role in the effective permeability of tight hydrocarbon or geothermal reservoirs. One issue is the extent to which both the long systematic and smaller cross fractures can be simultaneously critically stressed under a given stress condition. Fractures in an orthogonal network form by opening mode-I displacements in which the main component is separation of the two fracture walls. This opening is driven by effective tensile stresses as the smallest principle stress acting perpendicular to the fracture wall, which accords with linear elastic fracture mechanics. What has been well recognized in previous field and modelling studies is how both the systematic fractures and perpendicular cross fractures require the minimum principle stress to act perpendicular to the fracture wall. Thus, these networks either require a rotation of the regional stress field or local perturbations in stress field. Using a mechanical finite element modelling software, a geological case of layer perpendicular systematic mode I opening fractures is generated. New in our study is that we not only address tensile stresses at the boundary, but also address models using pore fluid pressure. The local stress in between systematic fractures is then assessed in order to derive the probability and orientation of micro crack propagation using the theory of sub critical crack growth and Griffith’s theory. Under effective tensile conditions, the results indicate that in between critically spaced systematic fractures, local effective tensile stresses flip. Therefore the orientation of the least principle stress will rotate 90 , hence an orthogonal fracture is more likely to form. Our new findings for models with pore fluid pressures instead of boundary tension show that the magnitude of effective tension in between systematic fractures is reduced but does not remove the occurring stress flip. However, putting effective tension on the boundaries will give overestimates in the reduction of the local effective tensile stress perpendicular to the larger systematic fractures and therefore the magnitude of the stress flip. In conclusion, both model approaches indicate that orthogonal fractures can form while experiencing one regional stress regime. This also means that under these specific loading and locally perturbed stress conditions both sets of orthogonal fractures stay open and can provide a pathway for fluid circulation. @en

The Early Jurassic (Toarcian) Shales in Northern Europe are investigated as possible unconventional sources for gas, where gas in shales is trapped in poorly connected micro pores and is sorbed within particles of organic material and clay minerals in the matrix of the host rock. Having a dual permeable medium consisting of a high permeable fracture network together with a tight shale matrix will improve gas flow rates from matrix to well. The Whitby Mudstone is currently outcropping on the Yorkshire coast hence getting sufficient sample material for permeability experiments is easily available, in combination with mapping of the natural occurring fractures in the cliffs and pavements along the coast this area is an ideal natural analogue to investigate matrix characteristics in combination with the natural fracture network. The studies show that fracture spacing on average is in the order of 10 centimeters and that in combination with a matrix permeability of 1∙10-18 m2 results in gas residue times in the matrix in the order of hours to tens of days depending on the input parameters used. @en

A fracture network arrangement is quantified across an isolated carbonate platform from outcrop and aerial imagery to address its impact on fluid flow. The network is described in terms of fracture density, orientation, and length distribution parameters. Of particular interest is the role of fracture cross connections and abutments on the effective permeability. Hence, the flow simulations explicitly account for network topology by adopting Discrete-Fracture-and-Matrix description. The interior of the Latemar carbonate platform (Dolomites, Italy) is taken as outcrop analogue for subsurface reservoirs of isolated carbonate build-ups that exhibit a fracture-dominated permeability. New is our dual strategy to describe the fracture network both as deterministic- and stochastic-based inputs for flow simulations. The fracture geometries are captured explicitly and form a multiscale data set by integration of interpretations from outcrops, airborne imagery, and lidar. The deterministic network descriptions form the basis for descriptive rules that are diagnostic of the complex natural fracture arrangement. The fracture networks exhibit a variable degree of multitier hierarchies with smaller-sized fractures abutting against larger fractures under both right and oblique angles. The influence of network topology on connectivity is quantified using Discrete-Fracture-Single phase fluid flow simulations. The simulation results show that the effective permeability for the fracture and matrix ensemble can be 50 to 400 times higher than the matrix permeability of 1.0 · 10^-14 m². The permeability enhancement is strongly controlled by the connectivity of the fracture network. Therefore, the degree of intersecting and abutting fractures should be captured from outcrops with accuracy to be of value as analogue.

@en