Falls are responsible for a large proportion of serious injuries and deaths among cyclists [1-4]. A common fall scenario is loss of balance during an emergency braking maneuver to avoid another vehicle [5-7]. Automated Vehicles (AV) have the potential to prevent these critical scenarios between bicycle and cars. However, current Threat Assessment Algorithms (TAA) used by AVs only consider collision avoidance to decide upon safe gaps and decelerations when interacting wih cyclists and do not consider bicycle specific balance-related constraints. To date, no studies have addressed this risk of falls in safety critical scenarios. Yet, given the bicycle dynamics, we hypothesized that the existing TAA may be inaccurate in predicting the threat of cyclist falls and misclassify unsafe interactions. To test this hypothesis, this study developed a simple Newtonian mechanics-based model that calculates the performance of two existing TAAs in four critical scenarios with two road conditions. Tue four scenarios are: (1) a crossing scenario and a bicycle following lead car scenario in which the car either (2) suddenly braked, (3) halted or (4) accelerated from standstill. These scenarios have been identified by bicycle-car conflict studies as common scenarios where the car driver elicits an emergency braking response of the cyclist [8-11] and are illustrated in Figure 1. The two TAAs are Time-to-Collision (TTC) and Headway (H). These TAAs are commonly used by AVs in the four critical scenarios that will be modelled. The two road conditions are a flat dry road and also a downhill wet road, which serves as a worst-case condition for loss of balance during emergency braking [12].@en

Objective: Sport research often requires human motion capture of an athlete. It can, however, be labour-intensive and difficult to select the right system, while manufacturers report on specifications which are determined in set-ups that largely differ from sport research in terms of volume, environment and motion. The aim of this review is to assist researchers in the selection of a suitable motion capture system for their experimental set-up for sport applications. An open online platform is initiated, to support (sport)researchers in the selection of a system and to enable them to contribute and update the overview. Design: systematic review; Method: Electronic searches in Scopus, Web of Science and Google Scholar were performed, and the reference lists of the screened articles were scrutinised to determine human motion capture systems used in academically published studies on sport analysis. Results: An overview of 17 human motion capture systems is provided, reporting the general specifications given by the manufacturer (weight and size of the sensors, maximum capture volume, environmental feasibilities), and calibration specifications as determined in peer-reviewed studies. The accuracy of each system is plotted against the measurement range. Conclusion: The overview and chart can assist researchers in the selection of a suitable measurement system. To increase the robustness of the database and to keep up with technological developments, we encourage researchers to perform an accuracy test prior to their experiment and to add to the chart and the system overview (online, open access).

@en

This study performed an analysis of the push-off forces of elite-short-track speed skaters using a new designed instrumented short-track speed skate with the aim to improve short-track skating performance. Four different skating strokes were distinguished for short-track speed skaters at speed. The strokes differed in stroke time, force level in both normal and lateral directions, and the centre of pressure (COP) on the blade. Within the homogeneous group of male elite speed skaters (N = 6), diversity of execution of the force patterns in the four phases of skating was evident, while skating at the same velocities. The male participants (N = 6) with a better personal record (PR) kept the COP more to the rear of their blades while hanging into the curve (r = 0.82, p < 0.05), leaving the curve (r = 0.86, p < 0.05), and entering the straight (r = 0.76, p < 0.10). Furthermore, the male skaters with a better PR showed a trend of a lower lateral peak force while entering the curve (r = 0.74, p < 0.10). Females showed a trend towards applying higher body weight normalised lateral forces than the males, while skating at imposed lower velocities.

@en

Descend technique and performance vary among elite racing cyclists and it is not clear what slower riders should do to improve their performance. An observation study was performed of the descending technique of members of a World Tour cycling team and the technique of each member was compared with the fastest descender amongst them. The obtained data gives us guidelines for rider specific feedback in order to improve his performance. The bicycles were equipped with a system that could measure: velocity, cadence, pedal power, position, steer angle, 3D orientation, rotational speeds and linear accelerations of the rear frame and brake force front and rear. From our observation study, the brake point and apex position turned out to be distinctive indicators of a fast cornering technique in a descent for a tight, hairpin corner. These two indicators can be used as feedback for a slower rider to improve his descend performance.@en