This paper proposes a solution to the circuit topology of heavy-duty electric vehicle (HDEV) chargers. In light of the original hybrid rectifier, a new unidirectional Input-Parallel-Output-Series (IPOS) three-phase hybrid rectifier is proposed and analyzed. The IPOS topology is advantageous at ultra-high power rating to interface the next-generation HDEV batteries which require a high and wide output voltage range of 800~1500 V with available 600/1200V commercial semiconductors. Moreover, the proposed topology is efficient, cost-effective, and scalable with the grid input current harmonic components in compliance with the IEEE-519 standard. The benefits of the IPOS topology are supported by circuit derivation, control strategy, analytical modelling, simulation, and experimental verification.

@en

This article proposes an analytical methodology to evaluate the performance of the main partial power processing (PPP) architectures in terms of the improvements in the system's conversion efficiency. This analysis considers the influence of the system's voltage gain, the auxiliary dc/dc converter's efficiency, and the possibility of bidirectional power flow. Herein, the key PPP architectures are, thus, modeled and benchmarked. The presented results attest to the series configuration as the most efficient PPP circuit solution, with no limits on the system voltage gain, contrary to the generalized results found in today's literature. To assess these results and the significance of the proposed analysis, a well-known, simple, and cost-effective flyback topology has been designed and tested for a series PPP circuit solution able to effectively interface a 5-kW battery energy storage system (BESS) to a 700-V dc grid. A relatively high power conversion efficiency and compact hardware are achieved due to the reduced size requirements on the input and output filtering stages. Above all, while explaining the PPP concept, this study shows that even converter circuits known for their low power efficiency can be used to derive highly efficient systems. A design approach is, thus, provided to facilitate the design of the presented PPP circuit, and measurements are, finally, carried out to compare the obtained results with the expected ones derived from the developed analytical models.

@en

The inherently intermittent nature of photovoltaic (PV) energy has brought increasing interest towards the integration between PV sources and Battery Energy Storage Systems (BESS). In this paper, a Series Partial Power Processing (PPP) converter based on Capacitive Power Transfer (CPT) is proposed to integrate PV and BESS in a grid-connected inverter system. The proposed converter has been simulated according to a PV string capable to provide 1430 W under full irradiance conditions, a BESS nominal voltage equal to 215 V and a solar inverter assumed to operate with a minimum voltage of 150 V and a maximum current of 10 A. Simulation tests carried out at different conditions of solar radiation and required load power aim at demonstrating the correct operation of the proposed system.@en

This paper presents the study of a 100kW electric vehicle (EV) fast charger based on a 12-pulse rectifier cascaded with two buck-type DC-DC converters. The proposed circuit operates with a triangular current shaping method which considerably improves the current harmonics performance of the system. The studied circuit is particularly suited for high power battery charging, being relatively simple to operate, requiring a low active semiconductor count (only two active switches), and because it employs circuit technologies well-established in the high power market. Above all, this EV fast charger meets the requirements of isolation, high efficiency, high output voltage and good power quality (low THD and unity power factor). This paper describes in detail the analytical modeling of the studied circuit, including the current harmonic input filter design which meets the grid standard requirement, and the loss modeling of the semiconductors and passive elements. The modeling and simulation results of the proposed 100 kW system are presented and analyzed.

@en