An on-load tap changer (OLTC) is prone to many different defects and degradation mechanisms due to its continuous operation under load condition. A high load current and high operation temperature accelerate the process of contact wear. Contacts erode due to the fact that under certain conditions the contacts develop a resistive layer due to hot insulation oil. As a major cause of OLTC failure, these defects might take place after some years of operation and their frequency increases with the operation time. Regular maintenance is applied due to degradation of the insulation oil. Dynamic resistance measurement (DRM) can be conducted during this maintenance to measure the resistance of the OLTC when it operates. The measurement results provide important information for assessing the actual condition of the OLTC. This paper aims to analyze the effect of test parameters on DRM results from service-aged OLTCs and describes the implementation of DRM in OLTC condition assessment. Two test parameters were selected for observation: the test current amplitude and the circuit resistance. Their amplitude was varied during laboratory experiments as well as on-site after regular maintenance. To quantify the various measurement results, an analytical tool using 4 performance parameters has been developed. Finally for interpretation, with the help of a three dimensional classification system which is presented in this paper, the actual condition of OLTCs can be identified during maintenance activities.@en

This paper discusses the recently developed analysis method for service aged power transformers equipped with an OLTC: dynamic resistance measurements (DRM). Because the on-load tap changer contributes to many power transformer failures the emphasis is on OLTC diagnosis. Off-line diagnosis of on-load tap changers during regular maintenance can detect maintenance errors and assess the condition of OLTC parts not accessible for inspection. DRM can be valuable to on-load tap changer (OLTC) condition assessment because of the large variety of defects and OLTC degradation mechanisms that can be found. This paper deals with the results that can be measured with DRM. Besides undisturbed DRM-data, most common deviations originating from degraded and defect tap changers will be discussed. It is explained how these different types of defects appear in the DRM results. The location and shape of the deviation can be used to find the cause and importance of the defect. A subdivision is made between OLTC's in good condition, OLTC's with increased contact resistance, OLTC's with open contacts and OLTC's with deviating switch times. By doing so, an overview of possible DRM results is gained. The seriousness of the defects is also discussed in this paper. Differences between the DRM results of different types of OLTC's will be discussed by showing results of DRM tests. Most graphs presented in this paper are recorded on service-aged OLTC's in the Dutch utility grid. Some measurement results are performed during experiments in a high voltage laboratory.@en

For advanced, non-destructive on-site condition monitoring of HV power cables up to 150 kV by partial discharge detection and dielectric losses measurement it is necessary to energize the disconnected cable system. One of the methods available for this purpose is based on applying damped AC voltages up to 150 kV. In this contribution, the use of modern technological solutions in power electronics and signal processing as well as in technical design and production methods will be discussed on the basis of ultra light system which is able to on-site service aged HV cables.@en

This paper discusses the recently developed analysis method for service aged power transformers. This is a complete approach to assess the condition of a power transformer, both the on-load tap changer as well as the transformer windings. This paper also presents several case studies of tap changer defects that are discovered with the dynamic resistance measurement function.@en

This paper describes important aspects of PD diagnostics of distribution power cables. PD parameter were discussed under consideration of attenuation and dispersive effects of cable characteristics. Field experiences with PD diagnosis on PILC and XLPE cables by energizing with Damped AC Voltage demonstrate relevant demands and the effective outcome for asset management decision support. The main difficulty is to evaluate the risc of PD occurrences on the reliability of the cable system. If an sufficient amount of PD diagnostic data for the cable components is available statistical methods can be used for determing threshold levels and relevant condition indexes for the asset management.@en