Recent constructions of large sea locks in the Netherlands at IJmuiden and Terneuzen have been accompanied by extensive hydraulic research, including physical scale model tests which took into account the effects of density differences across the lock heads during leveling operations. The case study presented here compares the situations and results from the studies of the two locations, and shows the importance of density effects in an accurate assessment of the hydrodynamic forces on the vessels and subsequently the forces on the mooring lines. Supposedly small differences in the local boundary conditions at the two locations lead to very different results, owing primarily to the differences in propagation of the density currents. Numerical models do not as yet predict this with sufficient accuracy. This further underlines the importance of doing extensive preliminary hydraulic investigations when designing large new shipping locks.

@en

This paper presents a novel design method to predict fatigue of flood gates due to dynamic wave loading. The accumulation of fatigue damage is predicted probabilistically over the entire lifetime of the structure rather than with a set of normative events. Load events are defined using a joint probability distribution of historical wind and water level data. The random phase-amplitude model is employed to obtain realisations of the wave state for every combination of environmental conditions. Linear wave theory and pressure-impulse theory are used to predict both quasi-steady and highly dynamic wave pressures. The stress response of the structure is predicted with a hybrid semi-analytical and finite element model. By applying a mode matching technique the fluid-structure interaction is solved in a computationally efficient manner. This facilitates the large number of simulations required for a comprehensive fatigue analysis without making concessions in the physical modelling. The fatigue damage is then evaluated with the linear Palmgren-Miner method by applying a rainflow algorithm. A Monte Carlo analysis is performed to estimate the expected fatigue lifetime of the structure. The modular structure of the model routine allows for easy adaptation to other situations where fatigue due to hydrodynamic loading is of interest. The design method is applied to a case study of a flood gate with an overhang inspired by the situation at the Afsluitdijk. Non-fundamental modes are taken into account without simplification of the fluid-structure interaction process and found to be governing for the fatigue damage for the studied case. Moreover, the interference of vibrations due to consecutive wave impacts is shown to have a significant influence on the outcome of the fatigue assessment. For the case study, the design method leads to a 10-20% reduction of the governing fatigue damage compared to a method commonly used in practice. At specific locations on the flood gate fatigue damage is found to be underestimated by current design methods. The presented design method is therefore found to be a significant improvement.@en

This paper investigates the effect of density differences on the forces acting on a moored vessel during lock operations, focusing on the effect of the position of the moored vessel in the lock chamber in the presence of density currents. The extensive scale-model research performed for the new sea lock in IJmuiden, The Netherlands has shown that the combination of density differences and an asymmetric layout of the moored vessel in the lock chamber may lead to high forces on the vessel that can largely exceed the allowable force limit. In particular, as a result of the density currents, forces in the transverse direction build up, pushing the vessel away from the chamber wall, during leveling and after opening the lock gate, leading to higher loads on the mooring lines. The forces caused by the density difference are the dominant forces and the performance of the leveling system cannot be assessed without taking this into account. Based on the results of the performed tests, criteria for achievable leveling times and allowable hydrodynamic forces during leveling are determined for the new sea lock of IJmuiden. Furthermore, the obtained results can be used for calibration or validation of numerical models that are valuable tools for the design of future locks.

@en