Typically precast girders are designed and utilized as simple supported members. Alternatively, the precast girders can be made continuous at the intermediate support using cast-in-place concrete topping. Once the girders are made continuous, time-dependent restraint moments will occur. The magnitude of the restraint moment is mainly affected by the creep and shrinkage behaviour of the concrete and the age of the girders at continuity. The developing restraint moment may affect the stress conditions near the support region and, in extreme cases, result in the loss of the integrity of the structural member. Currently, full-scale experimental campaign is underway on the shear behaviour precast continuous girders at Delft University of Technology. Inverted T girders are individually cast and later made continuous after a certain period. To investigate the influence of restrained action and quantify the prestress losses, fiber optic sensors (FOS) are embedded in the girders. By utilizing the FOS, the evolution of the concrete strain is monitored. This paper presents the measurement of the time-dependent strains. Furthermore, the concrete strains are analysed to evaluate the prestress loss and time-dependent restraint moment effect.@en

In this work, dynamic characterization of a simply supported beam is carried out during different steps in a failure load test. The main goal of this work is to evaluate the evolution of the structural dynamic parameters of the beam with different status of damage. Real-scale prestressed concrete beams are tested to investigate its shear behaviour as a part of a large research program at TU Delft. Four dynamic tests are performed at different damage status of the beam: firstly in the initial or undamaged condition; secondly after the first flexural cracks; then, after shear cracking; and finally in the full damaged condition. The dynamic excitation is performed with an impact load at fixed location on the top of the beam and the vibration data is recorded by three different systems. The first one is a cost-effective and open source monitoring equipment, consisting of seven low-cost accelerometers. The second system is based on five trusted high performance accelerometers. The last one is a commercial alternative consisting of four high accuracy piezoelectric accelerometers. Acceleration data is analysed afterwards using Operational Modal Analysis techniques to obtain modal frequencies, modal shapes and damping of the structure in the different states. The obtained dynamic behaviour of the structure and its results are discussed and compared. It is concluded that a change in the frequency of the first flexural mode is only observed when the damage in the beam is very significant, while no changes are observed with the occurrence of flexural and shear cracks.@en

In old Dutch inner cities like Amsterdam a large number of steel-concrete bridge decks built between 1880 and 1960 remain in service nowadays and currently need assessment of their bearing capacity. A significant number of these decks were designed without any mechanical connectors like shear studs in the interface between concrete and steel. Moreover, the concrete decks were designed with only shrinkage reinforcement in both directions on the top layer of concrete. No additional transverse reinforcement was placed that can ensure proper (re)distribution of loads after cracking. In order to study the bearing capacity of this deck typology, two specimens of an existing bridge were taken to the Stevin Lab of TU Delft and tested until failure. In this work, the experimental results of both tests are presented. Then, finite element models including nonlinear behaviour of the materials and the interface are presented and compared with the experimental observations. Experimental results show that the bearing capacity is achieved after yielding of the steel beams. Nevertheless, the ductility and transverse load distribution of the elements is affected by the interface behaviour and the poor detailing. The finite element simulation strategy used shows good agreement with the experiment and can be used for future assessments.
@en