Rogue waves are sudden and extreme occurrences, with heights that exceed twice the significant wave height of their neighboring waves. The formation of rogue waves has been attributed to several possible mechanisms such as linear superposition of random waves, dispersive focusing, and modulational instability. Recently, nonlinear Fourier transforms (NFTs), which generalize the usual Fourier transform, have been leveraged to analyze oceanic rogue waves. Next to the usual linear Fourier modes, NFTs can additionally uncover nonlinear Fourier modes in time series that are usually hidden. However, so far only individual oceanic rogue waves have been analyzed using NFTs in the literature. Moreover, the completely different types of nonlinear Fourier modes have been observed in these studies. Exploiting twelve years of field measurement data from an ocean buoy, we apply the nonlinear Fourier transform (NFT) for the nonlinear Schrödinger equation (NLSE) (referred to NLSE-NFT) to a large dataset of measured rogue waves. While the NLSE-NFT has been used to analyze rogue waves before, this is the first time that it is systematically applied to a large real-world dataset of deep-water rogue waves. We categorize the measured rogue waves into four types based on the characteristics of the largest nonlinear mode: stable, small breather, large breather and (envelope) soliton. We find that all types can occur at a single site, and investigate which conditions are dominated by a single type at the measurement site. The one and two-dimensional Benjamin-Feir indices (BFIs) are employed to examine the four types of nonlinear spectra. Furthermore, we verify on a part of the data set that for the localized types, the largest nonlinear Fourier mode can be attributed directly to the rogue wave, and investigate the relation between the height of the rogue waves and that of the dominant nonlinear Fourier mode. While the dominant nonlinear Fourier mode in general only contributes a small fraction of the rogue wave, we find that soliton modes can contribute up to half of the rogue wave. Since the NLSE does not account for directional spreading, the classification is repeated for the first quartile with the lowest directional spreading for each type. Similar results are obtained.@en

The shallow waters off the coast of Norderney in the southern North Sea are characterised by a higher frequency of rogue wave occurrences than expected. Here, rogue waves refer to waves exceeding twice the significant wave height. The role of nonlinear processes in the generation of rogue waves at this location is currently unclear. Within the framework of the Korteweg–de Vries (KdV) equation, we investigated the discrete soliton spectra of measured time series at Norderney to determine differences between time series with and without rogue waves. For this purpose, we applied a nonlinear Fourier transform (NLFT) based on the Korteweg–de Vries equation with vanishing boundary conditions (vKdV-NLFT). At measurement sites where the propagation of waves can be described by the KdV equation, the solitons in the discrete nonlinear vKdV-NLFT spectrum correspond to physical solitons. We do not know whether this is the case at the considered measurement site. In this paper, we use the nonlinear spectrum to classify rogue wave and non-rogue wave time series. More specifically, we investigate if the discrete nonlinear spectra of measured time series with visible rogue waves differ from those without rogue waves. Whether or not the discrete part of the nonlinear spectrum corresponds to solitons with respect to the conditions at the measurement site is not relevant in this case, as we are not concerned with how these spectra change during propagation. For each time series containing a rogue wave, we were able to identify at least one soliton in the nonlinear spectrum that contributed to the occurrence of the rogue wave in that time series. The amplitudes of these solitons were found to be smaller than the crest height of the corresponding rogue wave, and interaction with the continuous wave spectrum is needed to fully explain the observed rogue wave. Time series with and without rogue waves showed different characteristic soliton spectra. In most of the spectra calculated from rogue wave time series, most of the solitons clustered around similar heights, but the largest soliton was outstanding, with an amplitude significantly larger than all other solitons. The presence of a clearly outstanding soliton in the spectrum was found to be an indicator pointing towards the enhanced probability of the occurrence of a rogue wave in the time series. Similarly, when the discrete spectrum appears as a cluster of solitons without the presence of a clearly outstanding soliton, the presence of a rogue wave in the observed time series is unlikely. These results suggest that soliton-like and nonlinear processes substantially contribute to the enhanced occurrence of rogue waves off Norderney.@en

When a large number of solitons dominates the dynamics of a system, scientists describe this collective behaviour of solitons as a soliton gas. Soliton gases are currently the subject of intense practical and theoretical investigations. The existence of soliton gases has been confirmed in experiments, but is not clear what kind of sea states might lead to soliton gases. Therefore, in order to determine the wave parameters for sea states that lead to soliton gases, large numbers of surface wave elevations are generated by the well-known JOSNWAP model in this paper. Here, we only discuss soliton gases in deep water governed by the nonlinear Schrödinger (NLS) equation. The nonlinear Fourier transform (NFT) with vanishing boundary conditions is applied to the simulated ocean surface waves. The resulting nonlinear Fourier spectrum is used to calculate the energy of radiation waves and solitons. We investigate which JONSWAP parameters result in sea states that can be characterized as soliton gases, and find that a large Phillip’s parameter α, a large peak enhancement parameter γ and a short peak period T_P are important factors for soliton gas conditions. The results allow researchers to estimate how likely soliton gases are in deep waters. Furthermore, we find that the appearance of rogue waves is slightly increased in highly nonlinear sea states with soliton gas-like conditions.

@en

Rogue waves are extreme waves in the ocean that appear from nowhere and disappear without a trace. They are usually modelled by the nonlinear Schrödinger equation (NLS), which describes nonlinear phenomena such as modulational instability and solitons on finite backgrounds. In this study, the periodic nonlinear Fourier transform (NFT) for the NLS equation is applied to simulate ocean surface waves in deep water. The temporal and spatial structures of surface waves are obtained by evolving JONSWAP time series using the NLS equation. Several parameters extracted from the NFT spectra of the initial time series are investigated as predictors for the maximum wave height during evolution. We investigate several parameters from the literature, and find that with suitably optimized coefficients, a NFT-based parameter based on the largest unstable mode has a good correlation with the overall maximum wave amplitude. This new spectral criterion can contribute to rogue wave forecasting under extreme sea states.

@en

We propose a novel method to determine the average water depth from shallow, weakly nonlinear water waves that are approximated by the Korteweg-de Vries equation. Our identification method only requires free-surface measurements from two wave gauges aligned in the direction of wave propagation. The method we propose is based on comparing solitonic components in wave packets, which are computed using the nonlinear Fourier transform (NFT) (typical time-series data often contains at least some solitonic components, even when these components are not directly visible). When the correct water depth is used for the normalisation of the wave, the solitonic components found by the NFT remain constant as the wave packet propagates, whereas any other water depth will result in solitonic components that do not remain constant. The basic idea is thus to iteratively determine the water depth that leads to a best fit between the solitonic components of time series measurements at two different gauge positions. We present a proof-of-concept on experimental bore data generated in a wave flume, where the identified water depth is within 5% of the measured value.@en

In this paper, we study the propagation of bores over a long distance. We employ experimental data as input for numerical simulations using COULWAVE. The experimental flume is extended numerically to an effective relative length of x/h=3000, which allows all far-field solitons to emerge from the undular bore in the simulation data. We apply the periodic KdV-based nonlinear Fourier transform (KdV-NFT) to the time series taken at different numerical gauges and compare the results with those of the conventional Fourier transform. We find that the periodic KdV-NFT reliably predicts the number and the amplitudes of all far-field solitons from the near-field data long before the solitons start to emerge from the bore, even though the propagation is only approximated by the KdV. It is the first time that the predictions of the KdV-NFT are demonstrated over such long distances in a realistic set-up. In contrast, the conventional linear FT is unable to reveal the hidden solitons in the bore. We repeat our analyses using space instead of time series to investigate whether the space or time version of the KdV provides better predictions. Finally, we show how stepwise superposition of the determined solitons, including the nonlinear interactions between individual solitons, returns the analysed initial bore data.@en

Large vessels propagating in narrow, shallow maritime waterways generate a system of ship-induced waves consisting of long-period primary waves and short-period secondary waves. Progressive long-period free-surface wave systems are governed by the Korteweg–de Vries (KdV) equation, and are known to possibly disperse into a train of solitons and trailing oscillatory waves in the far field. By application of the nonlinear Fourier transform based on the KdV equation (KdV-NFT), these far-field solitons can already be revealed in the nonlinear spectra of the near-field data. In this paper, we apply the KdV-NFT to measured ship-wave time series from experiments in order to investigate the solitonic structures of these strongly nonlinear waves. Furthermore, we present qualitative and quantitative relations between the spectral solitons from frequency-domain KdV-NFT and channel, geometry, ship dynamics and primary-wave height as obtained by time-domain analysis of the time series.

@en

In the past decade, observations in the German estuaries such as the rivers Elbe and Weser show increasingly serious damage to bank protection structures (groins and revetments). This damage is caused mainly by waves induced by the passing of big container ships in the shallow and narrow maritime waterways. These ship-induced 3D wave fields consist of long-periodic primary and short-periodic secondary wave components. Due to missing design approaches for the load of long-period waves on rubble-mound revetments, the current risk assessment for protective structures in maritime waterways is based on short-period, wind-induced waves. Therefore, the structures do not ensure sufficient stability against the long-period ship-induced wave loads within the estuaries. Within the research project “Parameterization of nonlinear ship-induced 3D wave fields for the hydraulic design of protective structures in maritime waterways (PaNSiWa)”, we apply nonlinear Fourier transforms (NFTs) on experimentally generated ship waves in maritime waterways. The objective of the project is to provide better understanding of the underlying nonlinear structure of the long-period primary waves and to separate the nonlinear spectral basic components within the ship-wave data from their nonlinear wave-wave interactions. In this paper, we present first analyses of the decomposition of ship-wave measurements from experimental tests and the identification of hidden solitons within the long-period primary ship wave. @en

Nonlinear Fourier Analysis (NFA) is a powerful tool for the analysis of hydrodynamic processes. The unique capabilities of NFA include, but are not limited to, the detection of hidden solitons and the detection of modulation instability, which are essential for the understanding of nonlinear phenomena such as rogue waves. However, even though NFA has been applied to many interesting problems, it remains a non-standard tool. Recently, an open source software library called FNFT has been released to the public. (FNFT is short for “Fast Nonlinear Fourier Transforms”.) The library in particular contains code for the efficient numerical NFA of hydrodynamic processes that are approximately governed by the nonlinear Schroedinger equation with periodic boundary conditions. Waves in deep water are a prime example for such a process. In this paper, we use FNFT to perform an exemplary NFA of typhoon data collected by wave buoys at the coast of Taiwan. Our goals are a) to demonstrate the application of FNFT in a practical scenario, and b) to compare the results of a NFA to an analysis based on the conventional linear Fourier transform. The exposition is deliberately educational, hopefully enabling others to use FNFT for similar analyses of their own data.@en

Bores propagating in shallow water transform into undular bores and, finally, into trains of solitons. The observed number and height of these undulations, and later discrete solitons, is strongly dependent on the propagation length of the bore. Empirical results show that the final height of the leading soliton in the far-field is twice the initial mean bore height. The complete disintegration of the initial bore into a train of solitons requires very long propagation lengths, but unfortunately these required distances are usually not available in experimental tests or nature. Therefore, the analysis of the bore decomposition for experimental data into solitons is difficult and requires further approaches. Previous studies have shown that by application of the nonlinear Fourier transform based on the Korteweg–de Vries equation (KdV-NFT) to bores and long-period waves propagating in constant depth, the number and height of all solitons can be reliably predicted already based on the initial bore-shaped free surface. Against this background, this study presents the systematic analysis of the leading-soliton amplitudes for non-breaking and breaking bores with different strengths in different water depths in order to validate the KdV-NFT results for non-breaking bores, and to show the limitations of wave breaking on the spectral results. The analytical results are compared with data from experimental tests, numerical simulations and other approaches from literature.@en

Many sea dikes along the coast of the North Sea are protected against wave loading and currents by riprap revetments that are grouted with mortar. The mortar bonds the individual stones of the top layer, thereby forming a coherent structure that is able to withstand normal forces and shear forces as well as momentums, thus leading to a planar load distribution. While this kind of revetment has been built for decades, its design is yet solely based on empirical knowledge. On the one hand, the current design practice of mortar-grouted riprap revetments may therefore potentially lead to an uneconomic design exceeding the load and safety criterion for a particular site. On the other hand, it is also possible that the current design practice will lead to a weaker revetment than is required for the load and safety criterion for a particular site. Therefore, the objective of the project "Wave Toad and Stability of Mortar-Grouted Riprap Revetments" is to derive a scientific basis for the design of mortar-grouted riprap revetments. In order to describe the structural integrity of mortar-grouted riprap revetments, the results of an assessment of the condition of revetments in the field and a literature research are used to describe mechanisms leading to damage of the revetments. For the mechanism "crack development in the top layer" a structural model is set up in order to describe the load and resistance in the limit state. The hydraulic load due to wave action was measured duringfull-scale model tests in the Targe Wave Flume in Hannover, Germany. The resistance and structural parameters were determined using mechanical and fracture mechanical tests with the individual components as well as with the compound material of mortar and stone. Furthermore, pull-out tests to determine the force for debonding of an individual stone were carried out in the field and under laboratory conditions. The models for the structural stability of mortar-grouted riprap revetments presented in this study describe the processes relevant for designing a mortar-grouted riprap revetment, namely "crack development in the top layer" and "debonding of an individual stone". For the functional dimensioning, the wave run-up height was determined and reduction coefficients for the EurOtop wave run-up formula have been established.

@en