Hydrogen, regarded as a clean energy carrier, holds potential for subsurface porous media storage to balance energy supply and demand. Investigating the interactions between hydrogen and porous media, especially the potential residual trapping during cyclic injection and production, becomes imperative. Experimental studies were conducted to examine the influence of flow rate and cyclic injection/production on hydrogen storage and recovery efficiency. Findings reveal generally low hydrogen saturation in brine-saturated porous media during storage process, due to notable flow instability. However, higher injection rates contribute to increased hydrogen saturation. Moreover, observations indicate that cyclic hydrogen storage and drainage may lead to hysteresis in hydrogen storage process. That is, cyclic hydrogen storage and drainage may result in undesired residual trapping of hydrogen in porous media. This study underscores the need for a comprehensive investigation to validate these observations, shedding light on the complexities of hydrogen storage dynamics in subsurface porous media.@en

Characterization of the microbial activity impacts on transport and storage of hydrogen is a crucial aspect of successful Underground Hydrogen Storage (UHS). Microbes can use hydrogen for their metabolism, which can then lead to formation of biofilms. Biofilms can potentially alter the wettability of the system and, consequently, impact the flow dynamics and trapping mechanisms in the reservoir. In this study, we investigate the impact of microbial activity on wettability of the hydrogen/brine/rock system, using the captive-bubble cell experimental approach. Apparent contact angles are measured for bubbles of pure hydrogen in contact with a solid surface inside a cell filled with living brine which contains sulphate reducing microbes. To investigate the impact of surface roughness, two different solid samples are used: a "rough" Bentheimer Sandstone sample and a "smooth" pure Quartz sample. It is found that, in systems where buoyancy and interfacial forces are the main acting forces, the impact of biofilm formation on the apparent contact angle highly depends on the surface roughness. For the "rough" Bentheimer sandstone, the apparent contact angle was unchanged by biofilm formation, while for the smooth pure Quartz sample the apparent contact angle decreased significantly, making the system more water-wet. This decrease in apparent contact angle is in contrast with an earlier study present in the literature where a significant increase in contact angle due to microbial activity was reported. The wettability of the biofilm is mainly determined by the consistency of the Extracellular Polymeric Substances (EPS) which depends on the growth conditions in the system. Therefore, to determine the impact of microbial activity on the wettability during UHS will require accurate replication of the reservoir conditions including surface roughness, chemical composition of the brine, the microbial community, as well as temperature, pressure and pH-value conditions.

@en