Renewable electricity generation will need to be rapidly scaled to address climate change and other environmental challenges. Doing so effectively will require an understanding of resource availability. We review estimates for renewable electricity of the global technical potential, defined as the amount of electricity that could be produced with current technologies when accounting for geographical and technical limitations as well as conversion efficiencies; economic potential, which also includes cost; and feasible potential, which accounts for societal and environmental constraints. We consider utility-scale and rooftop solar photovoltaics, concentrated solar power, onshore and offshore wind, hydropower, geothermal electricity, and ocean (wave, tidal, ocean thermal energy conversion, and salinity gradient energy) technologies. We find that the reported technical potential for each energy resource ranges over several orders of magnitude across and often within technologies. Therefore, we also discuss the main factors explaining why authors find such different results. According to this review and on the basis of the most robust studies, we find that technical potentials for utility-scale solar photovoltaic, concentrated solar power, onshore wind, and offshore wind are above 100 PWh/year. Hydropower, geothermal electricity, and ocean thermal energy conversion have technical potentials above 10 PWh/year. Rooftop solar photovoltaic, wave, and tidal have technical potentials above 1 PWh/year. Salinity gradient has a technical potential above 0.1 PWh/year. The literature assessing the global economic potential of renewables, which considers the cost of each renewable resource, shows that the economic potential is higher than current and near-future electricity demand. Fewer studies have calculated the global feasible potential, which considers societal and environmental constraints. While these ranges are useful for assessing the magnitude of available energy sources, they may omit challenges for large-scale renewable portfolios.

@en

The rapid uptake of renewable energy technologies in recent decades has increased the demand of energy researchers, policymakers and energy planners for reliable data on the spatial distribution of their costs and potentials. For onshore wind energy this has resulted in an active research field devoted to analysing these resources for regions, countries or globally. A particular thread of this research attempts to go beyond purely technical or spatial restrictions and determine the realistic, feasible or actual potential for wind energy. Motivated by these developments, this paper reviews methods and assumptions for analysing geographical, technical, economic and, finally, feasible onshore wind potentials. We address each of these potentials in turn, including aspects related to land eligibility criteria, energy meteorology, and technical developments of wind turbine characteristics such as power density, specific rotor power and spacing aspects. Economic aspects of potential assessments are central to future deployment and are discussed on a turbine and system level covering levelized costs depending on locations, and the system integration costs which are often overlooked in such analyses. Non-technical approaches include scenicness assessments of the landscape, constraints due to regulation or public opposition, expert and stakeholder workshops, willingness to pay/accept elicitations and socioeconomic cost-benefit studies. For each of these different potential estimations, the state of the art is critically discussed, with an attempt to derive best practice recommendations and highlight avenues for future research.

@en

The authors wish to point out a typesetting error in Equation (1) of the above paper, published as [1] in this journal. An addition sign “+” was mistakenly replaced with a multiplication sign “∙” in this equation, as shown in Equation (1a) below. [Formula presented] There correct version of this equation is given in Equation (1b): [Formula presented]where n is the lifetime of the technology, I0 the investment [$], Mt the annual costs in year t [$/year], Et energy produced in year t [MWh/year] and i the interest rate. The authors apologise for any inconveince caused. This minor error has no implications for the validity of the conclusions and recommendations presented in section 6 of the original paper.@en

A recent article in this journal claimed to assess the socio-technical potential for onshore wind energy in Europe. We find the article to be severely flawed and raise concerns in five general areas. Firstly, the term socio-technical is not precisely defined, and is used by the authors to refer to a potential that others term as merely technical. Secondly, the study fails to account for over a decade of research in wind energy resource assessments. Thirdly, there are multiple issues with the use of input data and, because the study is opaque about many details, the effect of these errors cannot be reproduced. Fourthly, the method assumes a very high wind turbine capacity density of 10.73 MW/km2 across 40% of the land area in Europe with a generic 30% capacity factor. Fifthly, the authors find an implausibly high onshore wind potential, with 120% more capacity and 70% more generation than the highest results given elsewhere in the literature. Overall, we conclude that new research at higher spatial resolutions can make a valuable contribution to wind resource potential assessments. However, due to the missing literature review, the lack of transparency and the overly simplistic methodology, Enevoldsen et al. (2019) potentially mislead fellow scientists, policy makers and the general public.@en