Extractive Distillation with Ionic Liquids: Pilot Plant Experiments and Conceptual Process Design

Other than for strictly personal use, it is not permitted to download, forward or distribute the text or part of it, without the consent of the author(s) and/or copyright holder(s), unless the work is under an open content license such as Creative Commons.

Faculty

Applied Sciences

Department

ChemE/Chemical Engineering

Research Group

ChemE/Transport Phenomena

Abstract

Ionic liquids (ILs) can replace conventional solvents in separation processes, such as extractive distillation (ED), because of their ability to selectively separate azeotropic/close boiling mixtures. Four case studies were selected: ethanol/water (1-ethyl-3-methylimidazolium dicyanamide, [emim][N(CN)2], and ethylene glycol, EG), 1-hexene/n-hexane (no suitable IL found), methylcyclohexane/toluene (1-hexyl-3-methylimidazolium tetracyanoborate, [hmim][B(CN)4], and N-methyl-2-pyrrolidone, NMP), and ethylbenzene/styrene (4-methyl-N-butylpyridinium tetrafluoroborate, [4-mebupy][BF4], and sulfolane). Pilot plant experiments proved that the developed models for ED could well describe the experimental results.

Conceptual processes were designed for the ED of three case studies. The ethanol/water process with [emim][N(CN)2] reduced the energy requirements with 16 % compared to the process with EG, provided that proper heat integration is implemented. The methylcyclohexane (MCH)/toluene process with [hmim][B(CN)4] required about 50 % less energy with heat integration than the conventional process with NMP with heat integration.

The IL [4-mebupy][BF4] reduced the energy requirement most compared to the conventional distillation for the ethylbenzene/styrene process (43.2 %), which is 5 % lower than with extractive distillation with sulfolane. However, the capital expenditures were about 23 % higher than for the sulfolane process. It can be concluded from the total annual costs that all studied ED processes outperform the current distillation process to obtain high purity styrene, but that ILs do not perform better than sulfolane.

The general conclusion of these four examples is that only in some special cases ILs can be more advantageously applied than conventional solvents in extractive distillation. The key performance points for ED are a high selectivity and high capacity, next to the solvent recovery and heat integration.