Effect of incoming flow conditions on air lubrication regimes

Journal article (2024)

Authors

Lina Nikolaidou Multi Phase Systems - Mechanical, Maritime and Materials Engineering
A. Laskari Multi Phase Systems - Mechanical, Maritime and Materials Engineering
T.J.C. van Terwisga Maritime Research Institute Netherlands (MARIN), Ship Hydromechanics and Structures - Mechanical, Maritime and Materials Engineering
C. Poelma Process and Energy
Research Group
Multi Phase Systems (Mechanical, Maritime and Materials Engineering) (TU Delft)
More Info
expand_more

Published Date

2024

Language

English

Faculty

Mechanical, Maritime and Materials Engineering

Department

Process and Energy

Research Group

Multi Phase Systems

Abstract

Different air phase regimes are formed by controlled air injection in a spatially developing flat plate turbulent boundary layer (TBL). The air is introduced via a slot type injector without the use of a backward-facing step or cavitator upstream of the air injection position. The effect of different incoming liquid flow characteristics on the different regimes is investigated by varying both the liquid freestream velocity and the incoming TBL thickness. The latter is realized through changing the position of the air injection along the length of the water tunnel facility. That resulted in a downstream distance based Reynolds number from 1 to 5 million. Three different air phase regimes are identified under different air flow rates and freestream velocities: the bubbly regime, the transitional, and the air layer regime. The morphological differences of each one are described and quantitative analysis is performed based on the non-wetted area in each condition. The incoming TBL as well as the flow around the air layer are measured with planar particle image velocimetry. The latter enabled the determination of the air layer thickness. In addition, the ratio of the air layer to the incoming boundary layer thickness tair/δ is also calculated (≈ 0.04 – 0.5). This is a significant dimensionless parameter for scaling, which indicates the extent to which the air layer is embedded within the incoming TBL. Depending on the incoming flow conditions, a two or three branch air layer is formed. The length of the air layer is found to increase with increasing liquid freestream velocities. A good agreement between the air layer length and a half gravity wave predicted by the dispersion relation is found. An increase of the air layer length is observed with a decreasing incoming TBL thickness. This is attributed to a decrease in the local mean velocity at the air–water interface due to the TBL growth. Finally, increasing the incoming TBL thickness delays the onset of the air layer regime.