3D-printed microfluidic cantilever with geometric burst valves for segmented aspiration of picolitre volumes

Master Thesis (2026)
Author(s)

K. Keresztes (TU Delft - Mechanical Engineering)

Contributor(s)

M.K. Ghatkesar – Mentor (TU Delft - Mechanical Engineering)

S.M. Khalil – Mentor (TU Delft - Mechanical Engineering)

A. Hunt – Graduation committee member (TU Delft - Mechanical Engineering)

V. van Steijn – Graduation committee member (TU Delft - Applied Sciences)

Faculty
Mechanical Engineering
More Info
expand_more
Publication Year
2026
Language
English
Graduation Date
13-11-2026
Awarding Institution
Delft University of Technology
Programme
Mechanical Engineering, High-Tech Engineering
Faculty
Mechanical Engineering
Page Views
6
Reuse Rights

Other than for strictly personal use, it is not permitted to download, forward or distribute the text or part of it, without the consent of the author(s) and/or copyright holder(s), unless the work is under an open content license such as Creative Commons.

Abstract

Bulk analysis masks cell-to-cell heterogeneity, whereas single-cell tools like Fluidic Force Microscopy (FluidFM) resolve individual signals. However, sequential multi-cell sampling requires probe replacement or washing to prevent diffusive mixing. Dual-channel segmented aspiration addresses this by isolating extracts with an immiscible phase, but reported minimum volumes (170 pL) remain far larger than typical mammalian cells (2-15 pL).
In this project, capillary pinning is leveraged for state-determined flow segmentation in a microfluidic AFM cantilever. Two channels meet at a T-junction delimited by geometric burst valves (GBVs) to decouple segmentation from actuation pulse duration, while an additional GBV defines the sample volume. The design was confirmed using a two-phase COMSOL model validated against analytical Young-Laplace predictions. The device was fabricated using multi-scale 3D printing, which combines digital light processing (DLP) used for printing the fluidic interface, and two-photon polymerisation (2PP) for printing the cantilever. Structural modelling validated against Laser Doppler Vibrometry (LDV) yielded an estimated cantilever stiffness of 1.12 N/m. Mounted on an AFM platform with a dual-channel pressure controller, the probe aspirated up to nine consecutive water samples using air as a separator phase. Optically estimated segmented volumes were 6.35 ± 0.37 pL (0.16% deviation from the 6.36 pL design volume; 5.8% relative standard deviation). This advances volume resolution beyond existing segmented probes while preserving AFM force-displacement curve acquisition.

Files

License info not available
warning

File under embargo until 13-11-2027