Pull-out force of grippers with initially-curved fingers based on Pseudo-Rigid Body modelling

Abstract

This thesis presents the state-of-the art gripping literature and the implementation and extension of an existing Pseudo-Rigid Body Modelling (PRBM) method for modelling initially-curved compliant grippers out of which a circular object is extracted. From the existing literature, challenges are found in the design and evaluation of concepts of initially-curved compliant grippers, mainly involving the relevant design parameters, such as the thickness and enclosing angle of the finger.

The main goal of this thesis is therefore to present and validate the pull-out force modelling for these fingers within defined load conditions to provide comprehensive insights into the relation between important design parameters, such as the enclosing angle and thickness of the finger.

This goal is accomplished by extending an existing 3R PRB-model for initially-curved beams with a fifth link that represents the object and analysing the kinematics and kinetics to determine the relation for the pull-out force of a gripper finger with defined dimensions and a known load case.

This model is validated by designing and building an experimental test setup in which the reaction forces of a initially-curved testpiece of PLA and stainless steel material are measured. Errors for the kinetics between 12 and 32 percent were determined, consisting primarily of systematic errors.

The validated model is used for a parametric study, where relations between relevant design parameters, such as the enclosing angle and thickness of an initially-curved compliant gripper finger, are determined and visualized in a design chart that are be applied in the design of an initially-curved enclosing gripper prototype.